MMS-10 Amplified Speaker System
(250-1096)                  Preparation               Faxback Doc. # 17013

CONNECTING TO SOUND SOURCES AND POWER

Depending on your computer's output jacks, you need either a shielded audio
cable, such as Radio Shack's Cat. No. 42-2351, or a Y-cable (Cat. No.
42-2475) to connect the MMS-10.  For assistance in selecting the correct
cable, consult your local Radio Shack store.

Follow these steps to connect the MMS-10 to your computer and to power.

NOTE:  Before you begin, be sure to turn off the power to all your
       computer's components.

1.  Plug the audio cable's left channel plug into the MMS-10's INPUT A, L
    terminal.  Then plug the audio cable's right channel plug into the MMS-
    10's INPUT A, R terminal.

2.  Plug the audio cable's other end into your computer's stereo output
    jack.

3.  If you want to connect an additional audio source, plug the left- and
    right-channel plugs of an additional audio cable into the MMS-10's
    INPUT B, R and L terminals.  Connect the audio cable's other end to the
    audio source.

    NOTE:  Adding an auxiliary audio source lets you mix sound from two
           sources, such as a CD player and a voice presentation.  If you
           are using a computer with enhanced sound, you can connect both
           your computer's sound and a music card.

4.  Plug the power cord into a standard AC outlet or approved power strip.

CONNECTING EXTERNAL SPEAKERS

You can connect a pair of external speakers to the MMS-10.  You must use
speakers that are rated at 8 or 4 ohm.

Follow these steps to connect the external speakers to the MMS-10.

NOTES:  We recommend that you use the shortest length of speaker wire
        possible.

        For best overall performance, be sure that your speaker wires are
        properly connected according to their polarity (positive to
        positive and negative to negative).

1.  Split 4 inches of the speaker wire.

2.  Remove about 1 inch of insulation from each wire's end.  Twist the
    exposed wire to secure all of the wire strands.

3.  Press and hold the EXTERNAL SPEAKER 'R's negative (-) terminal tab and
    insert the right speaker's negative (-) wire into the opening.  Then
    release the tab.

4.  Press and hold the EXTERNAL SPEAKER 'R's positive (+) terminal tab and
    insert the right speaker's positive (+) wire into the opening.  Then
    release the tab.

5.  Repeat Step 1 through 4 to connect the left speaker's wires.