Creative Labs CD Kit (250-0200/01/02) Specifications Faxback Doc. # 2898 Discovery CD 16 MUSIC SYNTHESIZER: Enhanced FM OPL3 synthesizer using four operators Frequency modulation FM sound generation Compatible with previous Sound Blaster versions and Adlib FM Two-operator mode: 20 voices (15 melodies and 5 percussion) Four-operator mode: 11 voices (6 melodies and 5 percussion STEREO DIGITIZED VOICE CHANNEL: 16-bit and 8-bit digitizing in stereo and monaural Standard format for PCM data Programmable sampling rate: 5 kHz to 44.1 kHz in 228 linear steps in DOS 16-bit and 8-bit DMA channels using a single interrupt FIFO butter for high speed data transfer Dynamic filtering for digital audio recording and playback BUILT-IN DIGITAL/ANALOG MIXER: Analog mixing of six audio sources: Digital audio (stereo) CD audio (stereo) Synthesized music (stereo) Extra line level audio (stereo) Microphone level audio (monaural) PC speaker (monaural) Software programmable volume control: Master volume (stereo, 32-level attenuation in 2-dB steps) Digital audio (stereo, 32-level attenuation in 2-dB steps) CD audio (stereo, 32-level attenuation in 2-dB steps) Synthesized music (stereo, 32-level attenuation in 2-dB steps) Extra line level audio (stereo, 32-level attenuation in 2-dB steps) Microphone level audio (monaural, 32-level attenuation in 2-dB steps) PC speaker (monaural, 4-level attenuation in 6-dB steps) Master treble and bass control (left and right channels): 16 levels from -14 dB to +14 dB steps Recording source control: Independent selection of input sources for both channels or a combination of the following: CD audio left channel CD audio right channel Synthesized music left channel Synthesized music right channel Line level audio left channel Line level audio right channel Microphone level audio Output and input gain control: BUILT-IN STEREO POWER AMPLIFIER Four watts per channel (PMPO) with four ohms stereo output Automatic gain control or fixed gain amplifier for microphone level Output at line level selectable through jumper settings MIDI INTERFACE Built-in MIDI interface for connection to external MIDI devices Sound Blaster compatible or MPU-401 UART mode MIDI specification fixed at 31.2 kHz FIFO for smooth operation Internal expansion option for Wave Blaster daughter board CD-ROM DRIVE Performance: Storage Capacity.......................................680 MB (12 cm disk) 180 MB (8 cm disk) Buffer Memory........................................................64 KB Transfer Rate..........................................150 KB/sec (normal) 300 KB/sec (double speed) Access Time............................................350 KB/sec (normal) 450 KB/sec (double speed) Audio Specifications: Headphone Out............................................0.6 Vrms (RL:32W) Line Out.................................................0.8 Vrms (RL:50W) Number of Channels.......................................................2 Frequency Response...........................100 Hz to 20 kHz (headphones) 20 Hz to 20 kHz (line out) Dynamic Range...........................................80 dB (headphones) 80 dB (line out) Signal-to-Noise Ratio...................................80 dB (headphones) Distortion..................................................0.2 % at 1 kHz Stereo Separation.......................................45 dB (headphones) 60 dB (line out) Chipset:...........................................................CT-2230 Note: Your CD-ROM is a double speed, internally mounted drive. It is both PhotoCD and MultiSession compatible. (ALL/tmc-02/24/95)