LP 400  (260-2888)             Print Density           Faxback Doc. # 4058

Adjusting the Print Density:

You can adjust the print density in five steps, from +2 to -2.  The greater
the value, the darker the printouts.  The factory default setting is 0.
The print density setting is retained in memory until you change it.

Note: Increasing the print density increases toner usage.

Follow these steps to adjust the print density.

1. While you hold down ON LINE, turn on the laser printer.  The printer
   displays DENSITY = 0 and the current paper size setting (LTR, for
   example).
2. Press UP ARROW or DOWN ARROW until the density number you want appears
   on the display.
3. Press SET to set the print density.
4. If the paper size setting differs from the paper size loaded in the
   multipaper cassette, press FUNCTION until the correct paper size appears
   on the display.
5. Press PRINT FONT/TEST to start a test print.

   If necessary, repeat Steps 2 and 3.

6. Press RESET to exit the density adjust mode.

(/BKL-06/13/96)