DMP-240  (260-2839)          RAM Upgrade                Faxback Doc. # 4356

 ┌──────────────────────────────────────────────────────────────────────┐
 │                              OPTIONAL RAM                            │
 │                                                                      │
 │ The expansion RAM chip (Cat.No. 26-2853) expands the printer's       │
 │ temporary memory to 40K bytes (internal 8K plus an additional 32K).  │
 │ Take your printer to a Radio Shack Service Center to have the chip   │
 │ installed.  Installation MUST be done by Service Center.             │
 └──────────────────────────────────────────────────────────────────────┘

┌──────────────┐
│Menu Options: │
└──────────────┘

The OPTN RAM Group appears only when you define macros with the optional 
RAM chip installed. Press SELECT when the SPECIAL/SET? message appears 
after the CHR TABLE menu group. The settings in this menu are common to 
all four macros.

The setup menu option will display on the LCD as follows:

   Group            Item               Set
   SPECIAL          OPTN RAM           BUFFER, DOWNLOAD

   Note: BUFFER is the default mode.

The optional RAM can be used in one of two ways for the IBM emulation of 
the DMP-240. The additional 32-K byte RAM area can be used as an additional
receive buffer (BUFFER), or an IBM font download area (DOWNLOAD).

The Epson mode of the printer will only allow the optional ram to be used 
as an additional receive buffer (BUFFER). If (DOWNLOAD) is selected, the
optional RAM area is disabled.

(css 07/27/93)