DMP-240  (260-2839)              Ribbon                 Faxback Doc. # 4357

Black Fabric (260-2824)
Color Fabric (RSU# 11846789)

If the ribbon cassette is already installed, simply check to see that it is
properly threaded between the ribbon mask and the print head.  To install
the optional color ribbon, see chapter 5, "Enhancing Your DMP-240".

If the standard ribbon cassette is not installed, or if you need to replace
it due to excessive wear or faint printing, follow this procedure:

1. Turn off the power switch.

NOTE: When you turn off the power, any information stored in the printer's
buffer is automatically lost.

2. While facing the front of the printer, lift up the back edge of the top
   cover and tilt it toward you. Open the front half of the top cover by
   lifting it toward you.  Then, lift the top cover straight up to remove
   it.

3. Move the print head to the middle of the exposed ribbon.

WARNING: The print head gets very hot during extended periods of printing.
Be sure to let the print head cool off before you touch it.

4. Remove the old ribbon cassette by gently pulling it upward.

5. Unwrap the new cassette.  Before inserting the new cassette, tighten the
   ribbon by turning the ribbon feed knob in the direction indicated by the
   arrow.

6. Hold the ribbon cassette with the ribbon feed knob facing up.

7. Place the flat end into the ribbon plate until it snaps into place.
   Then, thread thee ribbon between the ribbon mask (thin steel plate) and
   the print head.  Be careful not to get the ribbon between the ribbon
   mask and the paper guide (black plate).

8. Turn the ribbon feed knob in the direction indicated by the arrow to
   take up the slack in the ribbon.

9. Replace the top cover.  Insert the two tabs into the notches on top of
   the printer.  Gently lower the front half and then the back half of the
   top cover.

CAUTION: Printing without paper or ribbon can damage the print head or
platen.

(css/BKL-10/28/96)