DWP 210  
(260-1257)                 Dip Switch Settings        Faxback Doc. # 4596

The function switches can be found under the Switch Access Cover at the 
right rear of the printer, on the top of the printer.


              ┌───────────────────────────────┐
              │ ┌┬┬┐ ┌┬┬┐ ┌┬┬┐ ┌┬┬┐ ┌┬┬┐ ┌┬┬┐ │ CLOSED
              │ ├┴┴┤ ├┴┴┤ ├┴┴┤ ├┴┴┤ ├┴┴┤ ├┴┴┤ │   ^
              │ │  │ │  │ │  │ │  │ │  │ │  │ │   │
              │ │  │ │  │ │  │ │  │ │  │ │  │ │   │
              │ └──┘ └──┘ └──┘ └──┘ └──┘ └──┘ │   │
              │  1    2    3    4    5    6   │   v
              │              OPEN             │  OPEN
              └───────────────────────────────┘

Dip switch settings:
SWITCH  SYMBOL          OPEN      CLOSE

1   Interface           Serial    8-bit Parallel
2   Baud                1200      600
3   Paper Empty         Enable    Disable
4   Impact              Low       High
5   Self test           Not App   Applied
6   Auto logic seek     Applied   Not applied

The DIP Switch determines the initial status of the Printer at power ON 
(except Switch No. 4). Therefore, be sure to set the switches when the 
power is OFF!

AUTO LOGIC SEEK

The Printer automatically performs bidirectional logic-seek printing for 
maximum efficiency when DIP Switch No. 6 is set to the OPEN side and data 
for one line ends with a CR code. Character codes, space code, and CR code 
are handled in logic-seek mode, but other codes are not.

* NOTE: Use the Serial Interface only when the DWP-210 is connected to a 
  Color Computer.

SETTING THE PITCH SELECT SWITCH

Be sure to set the Pitch Select Switch (on the Operating Panel) to the 
position that corresponds to the Print Wheel you are using. That is, if you 
are using a Courier 10-pitch Wheel, for example, set the Switch to 10; if 
you are using a Proportional Space Wheel, set the Switch to PS.

Do not accidentally bump the Pitch Select Switch during printing. Unless 
you change the pitch via software, the current switch setup remains in 
effect. Once you change the pitch via software, you must turn the Power 
Switch off before you can use the Pitch Select Switch.

(dtc/tmc-12/02/95)