WP-101  (260-3970)          Ribbon Cassette           Faxback Doc. # 5198

Ribbon Cassette: Single-strike ribbon    260-3952
Prints up to 67,000 characters

Correction Tape: Lift-off type           260-3953
Removes up to 1,200 characters

You can check the amount of ribbon remaining by looking through the 
cassette window. If you see colored tape, replace the ribbon cassette with 
a new one. 

To Remove:
1. Be sure that the paper support panel is in its upright position. Then,
   lift the display to its highest position.
2. Hold the cassette as shown and pull up the cassette as shown and pull up
   the cassette arms to release the cassette.
3. Slide the ribbon cassette toward the paper support panel as you gently
   lift up the cassette to remove it.
To Install:
1. Before you install the cassette, be sure to remove the green tab and
   tighten the ribbon; it can not be tightened after you press the cassette
   into place. Turn the ribbon takeup knob counterclockwise to take up any
   slack in the ribbon. When you install a new ribbon, be sure to wind the
   colored portion of the ribbon into the cassette until it is no longer
   visible.
2. Fit the two projections on the bottom edge of the ribbon cassette into 
   the two holes in the ribbon cassette holder.
3. Carefully lower the front of the cassette. Be sure the ribbon fits 
   between the card holder and the print wheel.
4. Press down on the positions marked "A" in the illustration until the 
   ribbon snaps into place.
5. Turn the ribbon takeup knob counterclockwise as far as it will go. Then,
   turn it clockwise until it stops.

CORRECTION TAPE
To Remove:
1. Move the print head to the center of the carriage. Remove the ribbon
   cassette.
2. Remove the left and right spools from the spindles.
NOTE: Do not pull the spindle hub when removing the right spool. If you can
not get the right spool to come loose, you might be pulling on the hub. 
Move your fingers toward the right edge of the spool and try again.
3. Grasp both spools and move them toward the platen, keeping the tape as
   straight as possible.
4. Pull the spools away from each other to take up any slack in the tape 
   and lift it out.
To Install:
1. Unwind about 6 inches of the correction tape. Hold the spool with the 
   knob on it in your left hand. Hold the other spool in your right hand.
2. With your right hand, fit the full spool of correction tape onto the 
   right spindle; the smooth rim of the spool should face the right side of
   the WP-101. Push the spool firmly in place.
3. Keeping the correction tape fairly taut, carefully thread it behind the
   print wheel and the correction tape guides. Be sure that the sticky side
   of the correction tape faces the card holder (away from you).
4. Fit the empty spool onto the left spindle; the knob should face the left
   side of the WP-101. Push the spool until it snaps into place.
5. Turn the left spool counterclockwise until the colored portion of the 
   tape is no longer behind the print wheel.
NOTE: Be sure that the correction tape is behind both the left and right
      correction tape guides.
6. Replace the ribbon cassette.

(css/tmc-09/28/95)