Serial Mouse  (25-1040D)     Setting up the Mouse      Faxback Doc. # 5333

The mouse drivers that come with your Radio Shack computer's operating
system let your mouse work with your computer.  The drivers track mouse
position, keeps track of the position of the Mouse buttons, and display a
cursor on your computer screen.  If you do not have the mouse driver,
contact your local Radio Shack store.

We designed your mouse to be reliable and easy to use.  Follow the
instructions in this manual to install your mouse and to configure its
drivers for best operation with your software.

SET UP

Consult your computer manual for the location of the computer's serial
port.  If your serial port has a 25-pin female connector, you will need a
DB9 to DB25 adapter (Cat. No. 260-1388).  If your serial port has a 25-pin
connector, you will need a special Radio Shack adapter ( Cat. No.
260-0287).  To keep these connectors from coming loose, fasten the
connectors together with appropriate size screws.

1. Turn off your computer and all peripherals.

2. Rotate the ring door on the bottom of the mouse so that the arrow points
   to "O", and remove the small sponge packing material.  Replace the ring
   door so that the arrow points to "C."

3. Plug the connector into your computer's serial port.

   If you have two serial ports, you can plug the mouse connector into
   either one.  The mouse software automatically initializes the correct
   port.

4. Place the mouse on a flat surface such as a table or desktop.

   Place a mouse pad (Such as Cat. No. 260-0237) between the flat surface
   and the mouse to provide optimum traction and to keep the mouse
   mechanism clean.

5. Turn on your computer and run the mouse drivers, following the
   instructions in the next section.

(css/tmc/BKL-07/01/96)