Faxmate  (250-3063)            Settings                Faxback Doc. # 5388

To install this board observe the standard anti-static precautions. Verify
that the factory default settings will not interfere with installed boards.
Change  settings if necessary. Plug board in to computer slot. The Tandy
Faxmate is factory set for I/O address 2E0-2E7. The following table lists
other possible settings for the Faxmate board.


Switch:        1         2         3          Faxmate I/O Add.

               Up        Up        Up             220-227
               Up        Up        Dn             260-267
               Up        Dn        Up             2A0-2A7
               Up        Dn        Dn             2E0-2E7 *
               Dn        Up        Up             320-327
               Dn        Up        Dn             360-367
               Dn        Dn        Up             3A0-3A7
               Dn        Dn        Dn             3E0-3E7

* Factory Default Setting.

Note: If they are present Switches 4 and 5 must be set to the Down or OFF
position.

(css 08/02/93)
~