Speaker Wall Mounting  (400-0150B)   Installation     Faxback Doc. # 14211
Bracket

INSTRUCTIONS FOR ATTACHING BRACKET TO BACK OF THE SPEAKER

1.  Using one of the brackets as a pattern, mark two holes on the back of
    your speaker.

2.  Drill two 1/8" (.32cm) diameter holes as marked.

    NOTE:  Remove the back panel from the speaker cabinet before drilling
           holes.  If the back panel can not be removed, use extreme
           caution while drilling holes so as not to damage speakers.

3.  Fasten one bracket to the speaker with two wood screws, provided.

INSTRUCTIONS FOR ATTACHING BRACKET TO WALL

1.  Select a mounting site.

    NOTE:  Try to find a site with a solid wood backing.

2.  Using one of the brackets as a pattern, mark four holes on the wall.

3.  Drill four 1/8" (.32cm) diameter holes as marked.

4.  Fasten one bracket to the wall with four wood screws provided.

5.  Hang the speaker.

WARNING:  Woodscrews provided may pull out of sheetrock or wall paneling
          without a wood brace.  They might also pull out of the thin
          speaker panels or perforated particle board.  See "Alternate
          Mounting Hardware."

ALTERNATE MOUNTING HARDWARE

Hardware           For attaching to wall          For attaching to speaker

Moly Bolt          Use on sheetrock, wall         Use on thin panel or
                   paneling or thin wood          particle board.

Toggle Bolt        Use on sheetrock.              Do not use.

Woodscrew W/       Use on brick, concrete,        Use if woodscrew will
Plastic Sleeve     or paneling with particle      not hold alone.
                   board back.

Nut & Bolt         Use on thin partitions.        Use for thin panel or to
                                                  replace woodscrew.  When
                                                  used with large washer,
                                                  it is very good for
                                                  particle or fiber board.

(ALL-03/16/95)