Super Tweeter  (400-1310)       Installation          Faxback Doc. # 14241

For Surface Mounting Outside and Enclosure

If you're using the Super Tweeter with a normal or a low-efficiency
speaker system, you should add a Level Control such as Radio Shack Cat.
Number 40-980 and a protective capacitor (Catalog Number 272-998).

After you've connected the Tweeter properly, place it on top of the
loudspeaker enclosure.  Make several listening tests with the Tweeter
placed at different spots on top of the enclosure to determine which
position is best for your room's individual acoustics.  (Try positioning
the tweeter as far forward as possible; midway back; and all the way
back to get the phase exactly right.)

For Mounting Inside and Enclosure

Remove the Super Tweeter from its case, taking care to keep the crossover
network intact as you remove it.  For normal and low-efficiency speaker
designs, install a Level Control and capacitor.  With high-efficiency
designs, you may leave out the Level Control and capacitor and connect the
Tweeter.  Mount the Tweeter in the enclosure, making sure that the front
edge of the horn is flush with the baffle board.

CAUTION:  Crossover Network must be connected correctly to prevent low-
          frequency damage to the Tweeter.

(ALL-03/17/95)