Stereo L-Pad  (400-0978)       Installation           Faxback Doc. # 14257

CAUTION:  This L-Pad is designed to handle up to 75 watts of peak music
          power.  Continuous use at high power levels may result in
          overheating of the control.  To assure maximum life at high
          power levels, operate the control at settings of 5 to 10.
          Operating at setting of less than 4 limits the power dissipation
          capacity of the control.  Thus, adjust the main Amplifier for an
          overall level which permits this control to be adjusted at the
          high end of the range.

1.  Connect output from one channel of Amplifier/Receiver CHannel 1 INput
    terminals.  Be sure the common (-) lead is connected to left terminal
    (next to OUTput terminal).

2.  Connect output from the other channel of the Amplifier/Receiver to
    CHannel 2 INput terminals.  Be sure to connect the common (-) lead to
    left terminal.

3.  Attach the wires from one speaker to CHannel 1 OUTput terminals.  The
    wire from (+) terminal (usually marked +, or red dot) should be
    connected to right terminal and wire from (-) terminal (unmarked, or
    marked G. or Com.) to left terminal.

4.  Attach wires from another speaker to CHannel 2 OUTput terminals.
    Observe the polarity same as in step 3.

    NOTE:  You can use channel 1 or 2 for either left or right channel, as
           long as you are consistent throughout the connections.

    That is, if you connect left channel output from Amplifier to Channel
    1, left channel speaker must be connected to CHannel 1 OUTput
    terminals.  Otherwise, sound will be "out of phase" and you will lose
    some of the bass response.

5.  Two sets of mounting hardware are enclosed.  Use the blunt metal
    screws if you are mounting the L-pad in an electrical wall box.  Use
    the Wood screws to mount the L-pad in a cutout.

    In either case, you can use other decoration plate (or no decoration
    plate so the wall color will be see through the transparent acrylic
    face plate).  See reverse side for how to change/remove decoration
    plate.

ATTACHING THE DECORATION PLATE

1.  Pull the knob off.

2.  Remove nut and flat washer.

3.  Hold the face plate nad pull the attenuator off.

4.  Place decoration plate and face plate over the control shaft.
5.  Place flat washer over the control shaft and thread nut onto the
    bushing.

6.  Turn the shaft counter clockwise till it stops.

7.  Press nob over the shaft, with the pointer toward "O".

(ALL-03/17/95)