12" Polypropylene Cone (400-1026A) Specifications Faxback Doc. # 15876 Woofer Nominal Impedance:...................................................8 ohms Frequency Response:.........................................30 Hz - 3000 Hz Free Air Resonance (Fs) Frequency:....................................25 Hz Infinite Baffle Resonance Frequency:..................................23 Hz Piston Area (SD):.................................................0.0523 m2 Rated Power Input - Nominal:...........................................50 W RMS Thermal Power Limit (PMAX):.......................................100 W Flux Density (BL):..................................................6.66 TM DC Voice Coil Resistance (RE, ohms):...............................5.6 ohms Voice Coil Inductance (LVC at 1 kHz):...............................0.45 mH SPL:......................................................88 +/- 2 dB/1W/1m Moving Mass (Mms):...................................................61.5 g Electrical Q Factor (QES):.............................................1.13 Mechanical Q Factor (QMS):.............................................3.13 Total Q Factor:........................................................0.83 Equivalent Acoustic Volume (VAS):..................................297.19 I Mechanical Suspension Compliance (CMS, UM/N):......................766 UM/N Mechanical Mass of Cone Assembly and Free Air Load:.................61.46 g Mechanical Mass of Cone Assembly Only:..............................54.59 g Peak-to-Peak (maximum) Linear Excursion:............................2.90 mm Cutout:...............................................10 1/4 Inches/28.5 cm Depth:.................................................5 1/4 Inches/14.3 cm Power Handling:................................................50 Watts RMS Magnet Weight:......................................................17.7 oz Speaker Weight:.....................................................72.9 oz Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice. (ALL-07/13/95)