System 728 Mini  (130-1275)        Preparation         Faxback Doc. # 16539
Stereo Component System

NOTE:  Complete all connections before connecting to AC power and
       turning it on.

CONNECTING THE SPEAKERS

1.  Press the red speaker terminal tab labeled SPEAKER R. Ch + on the back
    of the system, insert the stripped end of the right speaker's striped
    wire into the terminal, then release the tab.

2.  Press the black speaker terminal tab labeled SPEAKER R. Ch - on the
    back of the system, insert the stripped end of the right speaker's
    other wire into the terminal, then release the tab.

3.  Repeat Steps 1 and 2 to connect the left speaker to SPEAKER L. Ch +
    and - terminals.

CONNECTING AN EXTERNAL AUDIO SOURCE

To connect an external audio source (such as a CD player or a cassette
deck) to your system, connect the source's left and right line level output
jacks to the AUX IN R and L jacks on the back of your system.

CONNECTING AN EXTERNAL ANTENNA

You can attach an FM or VHF antenna (not supplied) to the 300 ohm EXT. ANT.
terminals on the back of the system.

If you have an outside VHF TV antenna, you can use a signal splitter with a
300-ohm output to connect your stereo system and TV set to the same
antenna.  Your Local Radio Shack store has a wide selection of antennas,
connectors, and splitters.

INSTALLING THE REMOTE CONTROL'S BATTERIES

The remote control requires two AA batteries (not supplied) for power.  We
recommend alkaline batteries, such as Radio Shack Cat. No. 230-0557.

Follow these steps to install batteries.

1.  Press down and slide the battery compartment cover in the direction
    of the arrow.

2.  Install the batteries as indicated by the polarity symbols (+) and (-)
    marked inside the compartment.

3.  Replace the cover.

CAUTION:  If you are not going to use the remote control for a month or
          more, remove its batteries.  Weak batteries can leak damaging
          chemicals.

NOTE:  If the remote control operates erratically or does not work, replace
       both batteries.

CONNECTING TO POWER

After you complete all connections, plug the music system's supplied power
cord into a standard AC outlet.  The STAND BY indicator lights, and CLOCK
and AM 12:00 appear on the display (see "Setting the Clock").

Warning:  To prevent electric shock, the AC power cord plug's blades are
polarized and fit a polarized AC outlet only one way.  If you have 
difficulty inserting the plug, do not force it.  Turn it over and reinsert 
it.


(SP/all-08/16/95)