System 728 Mini  (130-1275)      Using the Tuner       Faxback Doc. # 16541
Stereo Component System

Press TUNER to use the system's tuner.  The indicator above TUNER lights.

NOTE:  When you select TUNER, the system automatically tunes to the station
       that was playing when the system was turned off or when it was last
       set to TUNER.

You can tune to AM or FM radio stations using manual, seek, or memory
tuning.

MANUAL TUNING

1.  Press BAND to select the desired AM or FM band.  AM or FM appears on
    the display.

    NOTES:  The system uses a built-in ferrite antenna for AM reception. 
            For the best AM reception, rotate the system.

            For the best FM reception, see "Connecting an External FM
            Antenna."

2.  Use FM MODE/AM BEAT to select the desired AM or FM band's mode.

    If you select FM:

    Press it in to select stereo.  The FM STEREO indicator lights when
    you receive an FM broadcast in stereo.

    Press it out to select monaural.  The sound is no longer in stereo,
    but reception should improve.

    If you selected AM, press it in or out to the position that gives the
    best reception.

3.  Repeatedly press TUNING UP or DOWN to tune up or down the selected
    band.  If you press and hold down TUNING UP or DOWN, the stereo tunes
    quickly.

AUTOMATIC SEEK TUNING

1.  Press BAND to select the desired AM or FM band.  AM or FM appears on
    the display.

2.  Press TUNING AUTO.  The system automatically searches up the band and
    stops when it finds the next strong station.

MEMORY TUNING

You can store up to 10 AM and 10 FM stations in memory.

Storing Stations in Memory

NOTE:  You can assign one frequency to each memory location.  When you 
       assign another frequency to the same memory location, the new
       frequency replaces the first one.

1.  Press BAND to select the desired AM or FM band.  AM or FM appears on
    the display.

2.  Using either manual or automatic seek tuning, select the station you
    want to store, then press MEMORY.

3.  While MEMORY appears on the display, follow these guidelines to store
    up to 10 stations in memory.

    NOTES:  You must store a station within 3 seconds.  If MEMORY
            disappears before you make the following entries, simply
            repeat this step.

            To store stations into memory locations 1-5, press a memory
            location button (1-5).  The station is stored, MEMORY
            disappears, and the display shows the frequency.

            To store stations into memory locations 6-10, press +5 then a 
            memory location button (1-5).  The station is stored, MEMORY
            disappears, and the display shows the frequency.

            This increases the memory location number by 5.  For example,
            if you press +5, then press memory location button 2, the
            radio stores the frequency you selected into memory location 7.

4.  Repeat Steps 1-3 to program stations in the other band.

Manually Tuning to a Preset Station

Press the desired memory location button (1 through 5) to directly select
a radio station stored in memory.  For preset stations 6 through 10, press
+5 then the desired memory location button.

Scanning the Preset Stations

Press M/SCAN.  The system scans the preset stations and plays each station
for 5 seconds.

NOTE:  Repeatedly press M/SCAN to quickly step through the stored stations.

To stop scanning at a desired station, within 5 seconds after the tuner
stops on that station, press DISPLAY or that station's memory location 
button.


(SP/all-08/16/95)