Stereo Speaker Selector  (400-0130)   Connections      Faxback Doc. # 16557
Switch

This switch, using non-shorting, widely-spaced contacts, allows convenient
switching of stereo pairs of speakers, ease of hook-up and reliability for
years.  Follow the installation steps carefully to ensure proper operation.

1.  Connect the leads from the LEFT speaker output of your
    amplifier/receiver to the switch terminals marked LEFT AMP + and -.  To
    maintain proper phasing of speakers, assign one wire of the speaker
    leads to the - side.  The wire may be red, or gold or have a ridge of
    the edge.

2.  Connect the leads from the RIGHT speaker output to the screw terminals
    marked RIGHT AMP + and -.  Make sure the same color or ridged wire also
    is assigned to the - terminal.

3.  Connect your first pair of speakers, left and right, to the terminals
    marked LEFT SPK 1 and RIGHT SPK 1, respectively.  Connect the colored
    or ridged wire from the common or negative terminal of the speaker to
    the proper screw of the switch.  Repeat the connections for your second
    or remote set of speakers using the SPK 2 terminals for LEFT and RIGHT.

NOTE:  If speaker wire is stranded, tightly twist or solder the exposed
       wire.  No strand must touch an adjacent speaker lead or terminal. 
       Damage to your amplifier output could result.

To Operate:  After placing the switch in a convenient location, merely
             rotate the selector knob to choose which speaker set will
             operate.


(ALL-08/17/95)