Chronomatic-291 AM/FM LED Clock Radio
(120-1591A)                 Preparation               Faxback Doc. # 17111

CONNECTING TO AC POWER

Plug the clock radio's power cord into a standard AC outlet.  The display
flashes.

BATTERY BACK-UP WITH BATTERY SENTINEL

The clock radio has a back-up power system that operates the clock and
alarm during a power failure.  The clock display goes off, but the clock
operates for at least 8 hours, and the alarm sounds for at least 10
minutes, if set.

The BATTERY SENTINEL indicator, a small red dot at the bottom right of the
display, appears if the battery is low, or if one is not installed.

Installing a Back-up Battery

The clock radio requires a 9-volt battery (not supplied) for its back-up
power system.  For the best performance, we recommend an alkaline battery,
such as Radio Shack Cat. No. 23-553.

CAUTION:  Use only a fresh battery of the required size and type.

NOTE:  To prevent unnecessary drain on the battery, install it only after
       connecting the clock radio to AC power.

1.  To remove the battery compartment cover, press down and slide it in
    the direction of the arrow.

2.  Snap the clock radio's battery contacts onto the battery terminals,
    then insert the battery into the compartment.  The BATTERY SENTINEL
    indicator turns off.

3.  Replace the cover.

WARNING:  Always dispose of old batteries promptly and properly.