System 735 Integrated Stereo Component System
(130-1283)                 Using the Tuner            Faxback Doc. # 17973


1.  Press TUNER to select the tuner.  The TUNER indicator lights.

2.  Press BAND SELECT until the desired radio band (AM, FM1, FM2, or FM3) 
    appears on the display.

3.  Tune to a radio station using manual, automatic or program tuning.

NOTES:  When you turn off the power, the System 735 memorizes the last
        station you tuned.  The tuner tunes to that station the next time
        you turn on the power.

        To receive an FM broadcast in stereo, make sure that AUTO is
        displayed.  If not, press MODE so AUTO is displayed.  STEREO
        appears when an FM broadcast is received in stereo.

        If the signal from an FM stereo station is weak and reception is
        poor, press MODE to change to monaural reception.  (AUTO is
        replaced by FM MONO on the display.)

MANUAL TUNING

1. Press MODE until AUTO disappears from the display.

2.  Repeatedly press TUNING DOWN or UP until the desired frequency appears
    on the display.  Press and hold DOWN or UP for faster tuning.

AUTOMATIC TUNING

1.  Press MODE until AUTO appears on the display.

2.  Briefly press TUNING DOWN or UP.  The tuner automatically locks on the
    next strong station.

NOTE:  In the automatic tuning mode, the tuner might not stop on distant
       or weak signal stations.

PROGRAM TUNING

You can store 6 AM and 18 FM stations so you can quickly tune to them.

Presetting Stations

1.  Press BAND SELECT until the desired radio band (AM, FM1, FM2, or FM3)
    appears on the display.

2.  Tune to the desired station using either manual or automatic tuning.

3.  Press and hold down the desired preset button (1-6) until ch stops
    flashing on the display and the preset memory number appears.  This
    stores the station in memory.

4.  Repeat Steps 1-3 to store up to six stations in each band (AM, FM1,
    FM2, or FM3).

NOTES:  New stations replace any old ones stored in the same memory
        locations.

        The preset stations stay in memory when the system is turned off.

        The memory contents will be lost during a power failure or if the
        power cord is unplugged for more than 2-3 days.  You must preset
        the stations again.

Selecting Preset Stations

When using the tuner's controls, select the desired band then press the
corresponding preset button (1-6) to select the desired preset station.

When using the remote control, repeatedly press PRESET to select the
desired preset station.  

CHANGING THE TUNING INCREMENT

The System 735's tuner is preset to tune frequencies in increments of 10
kHz for AM and 200 kHz for FM, which is standard in the United States.  In
Europe and some other parts of the world, frequencies are broadcast in
increments of 9 khz for AM and 50 khz for FM.

If you use the System 735 in these countries, follow these steps to change
the System 735's tuning increment.

NOTE:  If you change the System 735's tuning increment, the stereo erases
       any stations you stored in memory in the selected AM or FM band.

1.  Select the band for which you want to change the tuning increment.

2.  Turn off the power.

3.  While pressing BAND SELECT, press POWER/STANDBY.  The tuning increment
    changes to the other setting.

AM:  520-1710 kHz (10 kHz steps)

     522-1710 kHz (9 kHz steps)

FM:  87.9-107.9 MHz (200 kHz steps)

     87.5-108.0 MHz (50 khz steps)

Repeat these steps to change the tuning increment back to the original
setting.


(CS 11/9/95)