AM/FM 2 Band Clock Radio
(120-1481)                 Operation                  Faxback Doc. # 18714

1.  Connect the power plug to an AC 120V, 60 Hz outlet.

    When this is done, the clock will be lighted up and the minute hand of
    the clock will start moving.

2.  Set the correct time.

    This can be done by turning the time adjustment Knob 8 located on the
    back of the cabinet.

3.  Operation of the clock switch.

    The clock switch 6 has four control positions, namely, "AUTO"...
    "ON"..."OFF:..."ALARM' from lower to upper position in the due order.
    Operations for respective control positions are as follows:

    "OFF" position    Clock alone operates.

    "ON" position     Radio operates.

                      The operating mode of the radio is indicated by the
                      illuminated radio dial.

                      The operating mode of the radio is indicated by the
                      illuminated radio dial.

    "AUTO" position   The Radio is turned on at the preset time.  If
                      audible radio is not required, set the volume
                      control knob 3 in a position for subdued volume.

    "ALARM position"  At the preset time the radio starts.  In about 9
                      minutes the alarm sounds.  To silence the alarm,
                      turn the clock switch to the "AUTO" position.  When
                      this is done, the radio is kept on.

4.  Use of "Snooze lever" 5

    Set knob 6 in the "ALARM" position.  At the preset time the alarm
    sounds.  If the "Snooze lever" is depressed the alarm stops for about
    eight minutes.  When the pause period is over, the alarm resumes.  The
    operation of the radio continues.

5.  Use of "Sleep Timer" 7

    If you wish to fall asleep to music, set the select or knob 6 in the
    "OFF" position and set Knob 7 to the desired switch off time.  A
    maximum of 60 minutes can be optioned.

6.  Listening to the Radio.

    Select the desired frequency band FM/AM by means of the band selector
    knob 2.

    Tune the Radio to the desired station by turning the tuning knob 1.

    Adjust the loudness of the radio set by means of the volume control
    Knob 3.  The loudness increases as the knob is turned clockwise.  By
    using Knob 4, the tone may be controlled to high or low.


(br/SP-12/29/95)