Chronomatic 7
(120-1457)                 Operation                  Faxback Doc. # 18919

SET TIME

Set the correct time by pulling the rear panel knob out and turning it
clockwise.

SET ALARM

Push the rear panel knob in and turn it clockwise to the time you want to
wake up.

FUNCTION SELECTOR

  OFF - Radio off. 

   ON - Radio on. 

 AUTO - Wake up to radio. 

ALARM - Wake up to radio, alarm will sound approximately 10 minutes after 
        radio comes on. 

SLEEP TO MUSIC

Turn the Function Selector to AUTO or ALARM (for wake up) or to OFF.  Set 
the Timer Control for up to 60 minutes of music.  At the end of the time 
you set, the radio will turn itself off.

RADIO (Manual)

Turn Function Selector to ON.  Use SELECT switch to choose AM or FM.  Tune 
desired station.  Adjust VOLUME and TONE.  To turn radio off, turn Function
Selector to OFF.

WAKE TO MUSIC

Set the alarm to the time you want to get up.  Find the station you want,
set the Volume and Tone.  Turn the Function Selector to AUTO.

In the morning turn the Function Selector to OFF to silence the radio, or
ON for continued operation.  If you leave the switch at AUTO, the radio
will turn itself off in an hour and be ready to wake you again the next
morning.

WAKE TO MUSIC AND ALARM

Follow procedure above, but set Function Selector to ALARM.  The alarm will
sound approximately 10 minutes after the radio comes on.  To silence the
alarm turn the Function Control to any other position.

SNOOZE BAR

After the alarm has gone off, you can sleep an extra 10 minutes by pressing
the Snooze Bar.  At the end of 10 minutes the alarm will sound again.  This
can be repeated up to an hour, at which time, the alarm will no longer
sound.

ANTENNA

The built-in antennas should be adequate in most areas.  If FM reception is
weak, connect any 300 ohm antenna to the rear panel terminals.  Your Radio
Shack salesman is familiar with reception conditions in your area.  He can
advise you on how to solve your problem.

CAUTION:  This radio is designed exclusively for AC operation.  Do not
          operate it on a DC power source.

          Use lemon oil to polish the case.  Wax will give a glossier
          finish but may cause a built-up.  Use a soft, damp cloth to clean
          metal and plastic parts.  Do NOT use solvents or abrasives.


(/all-02/08/96)