CTR-95  (140-0727)              Operation              Faxback Doc. # 3379

RADIO OPERATION

Warning:  To protect your hearing, set VOLUME MIN/MAX to its lowest
          setting before you turn on the radio.

1.  Set FUNCTION to RADIO to turn on the radio.

2.  Set BAND to AM or FM for the desired band.

3.  Adjust TUNING to the desired station.

    Notes:  The AM antenna is built-in.  For the best AM reception, rotate
            the CTR-95.

            For the best FM reception, fully extend the telescoping
            antenna and swivel it to the position that produces the best
            reception.

CASSETTE PLAYER OPERATION

LOADING A CASSETTE TAPE

1.  Take up any slack in the tape by turning one of the cassette's hubs
    with a pencil.  If you do not remove excess slack, the tape might
    become tangled in the record/playback mechanism.

2.  Press STOP/EJECT to open the cassette compartment door.

3.  Load the cassette with its open edge up, the desired side facing out,
    and its full reel to the right.

4.  Gently close the compartment door.

PLAYING A CASSETTE TAPE

    Warning:  To protect your hearing, set VOLUME MIN/MAX to its lowest
              setting before you begin playing a cassette tape.

1.  Set FUNCTION to TAPE/RADIO OFF.

2.  Load a cassette tape.

3.  Press PLAY.  The cassette plays until it reaches the end of the side,
    then it automatically stops.

    Notes:  Press PAUSE to temporarily stop playback.  Press PAUSE again
            to resume playback.

            Press FAST-F or REWIND to rapidly wind the tape forward or
            backward.  Press STOP/EJECT, then PLAY again to resume play.

4.  Adjust VOLUME MIN/MAX to the desired listening level.

5.  Press STOP/EJECT to completely stop playback before it automatically
    stops.  Press STOP/EJECT again to open the cassette compartment and
    remove the cassette tape.

RECORDING

You can record from the radio or use the built-in microphone to make a
live recording.

    Notes:  Before you load a cassette tape for recording, be sure the
            erase-protection tabs are in place on the cassette tape you
            are recording onto.

            The CTR-95's Automatic Level Control (ALC) circuit
            automatically adjusts the recording level.  VOLUME MIN/MAX has
            no effect on recording.

Recording from the Radio

1.  Load a blank cassette tape or one you want to record over into the
    cassette compartment.

2.  Set FUNCTION to RADIO.

3.  Set BAND to FM or AM.

4.  Adjust TUNING to the station you want to record.

5.  Press RECORD to begin recording.  Both PLAY and RECORD lock down.

    Caution:  Do not force down RECORD.  This can damage the record
              mechanism.

    Note:  To temporarily stop recording, press PAUSE.

6.  Press STOP/EJECT to stop recording.

Making Live Recordings

Follow these steps to make live recordings using the built-in microphone.

1.  Set FUNCTION to TAPE/RADIO OFF.

2.  Load a blank cassette tape or one you want to record over into the
    cassette compartment.

3.  Place the CTR-95 2 or 3 feet from the recording source.

4.  Press RECORD to begin recording.  Both PLAY and RECORD lock down.

    Caution:  Do not force down RECORD.  This can damage the record
              mechanism.

    Note:  To temporarily stop recording.

(br/all-12/02/94)