AM/FM All Weather  (120-0452)        Operation         Faxback Doc. # 3681
Stereo Radio

Follow these steps to use the radio.

1.  Rotate VOL. counterclockwise until it stops.

2.  Remove the radio's rubber plug from the PHONES jack and plug the
    headphones (not supplied) into the jack.

    Note:  Connecting headphones powers the radio.

3.  Slide AM/FM to AM or FM.

4.  Adjust VOL. to a comfortable listening level.

5.  Rotate TUNING to your desired station.

6.  To turn off the radio, remove the headphones and insert the radio's
    rubber plug into the PHONES jack.

    Notes:  The headphones' cord acts as an FM antenna.  Reposition the
            cord to obtain the best reception.

            For AM stations, rotate the radio to the position that
            provides the best reception.

            To save battery power, remember to remove the headphones
            when you are not listening to the radio.

            To protect the receiver from water, insert the rubber plug
            into the headphone jack when you are not listening to the
            radio.

            To protect the receiver from water, insert the rubber plug
            into the headphone jack when you are not listening to the
            radio.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

    Set the volume to the lowest setting before you begin listening.
    After you begin listening, adjust the volume to a comfortable
    listening level.

    Do not listen at extremely high volume levels.  Extended high volume
    listening can lead to permanent hearing loss.

    Once you set the volume, do not increase it.  Over time, your ears
    adapt to the volume level, so a volume level that does not cause
    discomfort might still damage your hearing.

Traffic Safety

Do not wear headphones while operating a motor vehicle or riding a
bicycle.  This can create a traffic hazard and is illegal in some areas.

Even though some headphones are designed to let you hear some outside
sounds when you listen at normal volume levels, they still present a
traffic hazard.

USING THE BELT CLIP

For hands-free carrying, you can slide the clip over your belt.

To attach the belt clip, place it in the recessed area on the back of
the radio and slide it down until it snaps into place.

To detach the belt clip, lift the belt clips tab, slide the belt clip up,
and remove it.

USING THE ARMBAND

The removable armband allows hands-free movement while you listen to your
radio.

Follow these steps to attach the armband.

1.  Push the belt clip up and remove it from the radio, if necessary
    (see "Using the Belt Clip").

2.  Insert the free end of the armband down onto one of the belt clip's
    bars.

3.  Loop the armband and insert it onto the belt clip's other bar and
    pull it up far enough to stop the armband from slipping.

4.  Insert the free end of the armband through the buckle.

5.  Attach the belt clip to the radio.

    To lengthen the armband, slide the buckle toward the free end of the
    armband.  To shorten the armband, pull the free end of the armband
    in the opposite direction.  To tighten the armband, loop the free
    end through the first opening of the buckle and pull it until it
    tightens.

(br/all-12/19/94)