CD-6600 Compact Disc Automatic Changer
(420-5059)                 Troubleshooting            Faxback Doc. # 32154

If your CD changer is not working as it should, these suggestions might
help you solve the problem.  If the CD changer still does not operate
properly, take it to your local Radio Shack store for assistance.

    SYMPTOM                   POSSIBLE CAUSE             SUGGESTION

No power when POWER      Connected receiver/amplifier  Turn on receiver/
or POWER/STANDBY         not turned on.                amplifier.
is pressed.
                         Power problem.                Check the AC power
                                                       cord and AC outlet.

No sound.                Volume set to minimum         Adjust receiver/
                         on connected receiver/-       amplifier's volume.
                         amplifier.

                         CD changer not connected      Recheck connections
                         correctly to receiver/
                         amplifier.

                         Connected receiver/amplifier  Recheck input set-
                         not set to correct input.     ting on receiver/
                                                       amplifier.

CD changer does not      CD loaded backward.           Load CD correctly.
work.

Graphics around the      Shipping screw has not        Remove the shipping
disc number flash on     been removed.                 screw (see "Remov-
the display.                                           ing the Shipping
                                                       Screw").

Sound from CD skips.     CD is dirty or damaged.       Clean or repair CD
                                                       (see "CD Care
                                                       Tips"), or try a
                                                       new CD.

Abnormal CD or dis-      System memory must be         Reset the CD
play operation, but      reset.                        changer (see
button settings are                                    "Resetting the CD").
correct.

M-ERROR scolls           Shipping screw has not        Remove the shipping
across the display.      been removed.                 screw (see "Removing 
                                                       the Shipping 
                                                       Screw").

RESETTING THE CD CHANGER

If the CD changer does not work properly or displays M-ERROR after you
connect power, you might need to reset it.

    NOTE:  Resetting the CD changer does not clear any stored category or
           subcategory names.

To reset the CD changer, press POWER/STANDBY on the CD changer or POWER on
the remote control to turn it off.  Then press POWER/STANDBY or POWER to
turn it back on.

If the CD changer still does not work properly, unplug the CD changer's AC
power cord from the AC outlet, wait a few seconds, then plug it back in
again.

If M-ERROR scrolls across the display again or the CD changer still does
not work properly, contact your local Radio Shack store for assistance


(EB 4/22/96)
(BR 4/3/96)