Optimus Lab-1000 Semi-Automatic Belt Drive Turntable 
(420-2022)                 Connections                Faxback Doc. # 32546

CONNECTING THE TURNTABLE TO YOUR RECEIVER/AMPLIFIER

You can connect your LAB 1000 to a receiver or amplifier with a low-level
phono input (such as left and right PHONO jacks) or high-level input (such
as left and right AUX, TV, TAPE, or CD jacks).

CAUTIONS:  Be sure to follow all the installation instructions described in
           the enclosed "Safety Instructions."

           Do not connect the turntable to AC power until you complete all
           other connections.

           Do not place the turntable on top of the receiver/amplifier or
           on any other component that gets hot.
 
           To avoid possible damage to your receiver/amplifier, turn it off
           before making the following connections.

Plug the turntable's white (left) and red (right) plugs into the
appropriate jacks on your receiver/amplifier.

NOTE:  If you are not sure which type of input your receiver or amplifier
       has, check your receiver's/amplifier's owner's manual.

       To connect the turntable to a low-level phono input, plug the white
       and red plugs into the receiver/amplifier's left and right PHONO
       jacks.

       NOTE:  PRE-AMP-IN/PHONO-OUT (under the turntable's platter) should
              be set to PHONO-OUT.

       To connect the turntable to a high-level input, plug the white and
       red plugs into the receiver/amplifier's left and right AUX, TV,
       TAPE, or CD jacks.

       NOTE:  PRE-AMP-IN/PHONO-OUT (under the turntable's platter) should
              be set to PRE-AMP-IN.

CONNECTING POWER

After you connect the turntable to your receiver/amplifier, plug the
turntable's AC power cord into a switched or unswitched AC outlet on your
receiver/amplifier, or into a standard AC outlet.

CAUTION:  To prevent electric shock, the plug's blades are polarized and
          fit only one way.  If the plug does not fit easily, turn it over
          and try again.  Do not force the plug into the AC outlet.


(YO/EB 4/22/96)