System 730 Mini Stereo Component System
(130-1277)              Care and Maintenance          Faxback Doc. # 32566

Your Optimus System 730 Mini Stereo Component System is an example of
superior design and craftsmanship.  The following suggestions will help you
care for your System 730 so you can enjoy it for years.

    Keep the System 730 dry.  If it gets wet, wipe it dry immediately.
    Liquids might contain minerals that can corrode the electronic
    circuits.

    Handle the System 730 gently and carefully.  Dropping it can damage
    circuit boards and cases and can cause the System 730 to work
    improperly.

    Use and store the System 730 only in normal temperature environments.
    Temperature extremes can shorten the life of electronic devices and
    distort or melt plastic parts.

    Keep the System 730 away from dust and dirt, which can cause premature
    wear of parts.

    Wipe the System 730 with a damp cloth occasionally to keep it looking
    new.  Do not use harsh chemicals, cleaning solvents, or strong
    detergents to clean the System 730.

Modifying or tampering with the System 730's internal components can cause
a malfunction, might invalidate its warranty, and void your FCC
authorization to use it.  If your System 730 is not performing as it
should, take it to your local RadioShack store for assistance.

THE FCC WANTS YOU TO KNOW

This stereo system complies with the limits for a Class B digital device as
specified in Part 15 of FCC Rules.  These limits provide reasonable
protection against radio and TV interference in a residential area. 
However, your stereo system might cause TV or radio interference even when
it is operating properly.  To eliminate interference, you can try one or
more of the following corrective measures:

    Reorient or relocate the receiving antenna

    Increase the distance between the stereo system and the radio or TV

    Use outlets on different electrical circuits for the stereo system and
    the radio or TV

Consult your local RadioShack store if the problem still exists.

You must use shielded interface cables with this stereo system.

CLEANING THE TAPE-HANDLING PARTS

Dirt, dust or particles of a cassette tape's coating can accumulate on the
cassette deck tape heads, and other parts that the tape touches.  This can
greatly reduce the performance of the cassette decks.  Use the following
cleaning procedure for each deck after every 20 hours of tape player
operation.

1.  Be sure the system is off, then disconnect power.

2.  Open the cassette compartment door on each deck.

3.  Press PLAY to expose the tape-handling parts.

4.  Use a cotton swab dipped in denatured alcohol or tape head cleaning
    solution to clean each deck's record or play head, pinch roller,
    capstan and erase head.

5.  When you finish cleaning, close each deck's cassette compartment door
    and reconnect power.

Your local RadioShack store sells a complete line of cassette deck
cleaning supplies.


(RMF/all-05/07/96)