Stereo Infrared Cordless Headphone System
(330-1142)                 Operation                  Faxback Doc. # 32612

LISTENING SAFELY

To protect your hearing, follow these guidelines when you use headphones.

    Since a pop sounds each time you turn the headphones on and off, always
    turn on the headphone receiver before putting the headphones on your
    head and always remove the headphones from your head before you turn
    them off.

    Set the volume to the lowest setting before you begin listening, adjust
    the volume to a comfortable level.

    Do not listen at extremely high volume levels.  Extended high volume
    listening can lead to permanent hearing loss.

    Once you set the volume, do not increase it.  Over time your ears adapt
    to the volume level, so a volume level that does not cause discomfort
    might still damage your hearing.

USING THE SYSTEM

1.  Turn on your audio source.

2.  Set the transmitter's OFF/ON switch to ON.  The red power indicator
    lights.

    CAUTION:  The transmitter's surface heats slightly during operation. 
              Do not touch the transmitter's surface while it is on.

3.  Preset the audio source's volume level by adjusting its volume control
    until only the green indicator on the transmitter lights.

    NOTES:  The green indicator lights when the transmitter volume is at
            the optimum level.  Both indicators light when the
            transmitter's volume level is too high.  Neither indicator
            lights when the transmitter's volume level is too low.

            Once you preset the audio source's volume level, you do not
            need to readjust it.

4.  Set the headphone receiver's OFF/ON switch to ON.  The red power
    indicator lights.

5.  Put on the headphone receiver, then adjust VOL. on each earpiece to a
    comfortable listening level.

    NOTE:  To adjust the headphone receiver's size, pull down or push
           up on each end.

6.  To turn off the system, remove the headphones from your head, then set
    OFF/ON on the transmitter and the headphone receiver to OFF.

NOTE:  Be sure to turn off the system when you are not using it.


(WL/all-05/08/96)