SCT-57 High-Speed dubbing Stereo Cassette Deck (140-0677) Connections Faxback Doc. # 32620 Connecting to Your Receiver/Amplifier 1. Using one of the supplied audio cables, connect the cassette deck's L and R LINE OUTPUT jacks to the receiver/amplifier's left and right tape input jacks. 2. Using the other audio cable, connect the cassette deck's LINE INPUT jacks to the receiver/amplifier's tape output jacks. NOTE: If you are not sure which receiver/amplifier jacks to use, refer to your receiver/amplifier's owner's manual. Connecting the Remote Control Cable If you have an Optimus receiver/amplifier that has a remote control jack (labeled CONTROL IN/OUT), you can use the receiver/amplifier's remote control to operate the cassette deck. Connect the receiver/amplifier's CONTROL OUT jack to the cassette deck's CONTROL IN jack using the supplied remote control cable. If you have another Optimus audio component that has a remote control jack, connect the cassette deck's CONTROL OUT jack to the component's CONTROL IN jack. This relays the remote control signal from the receiver/amplifier to the other component. Connecting the CD-Deck Synchro Control Cable If you have an Optimus CD player that has a CD- DECK SYNCHRO control jack, connect the jack to your cassette deck's CD-DECK SYNCHRO control jack using the supplied CD-deck synchro control cable. This connection lets you easily make CD-to-cassette deck recordings. See "CD-Deck Synchro Recording" on Faxback Doc. # 32622. Connecting Power Carefully check all connections. Then plug the AC power cord into a standard AC outlet. The power cord's plug is polarized and fits only one way. The cassette deck automatically turns on. WARNING: To prevent electric shock, do not plug the power cord into an extension cord or other receptacle unless you can fully and easily insert the plug's blades. (BR/EB 4/24/96)