STA-60 Stereo Receiver
(310-2097)                   Specifications           Faxback Doc. # 33541


PRE-AMPLIFIER & AMPLIFIER

Audio Output Power at no more than 0.03 % Total
Harmonic Distortion into 8 ohms, over the audio
spectrum, 20 to 20,000 Hz:..........................65 watts per channel
                                                    (Minimum RMS Power,
                                                    both channels driven).
Frequency Response (1 watt) from 15 to 25,000 Hz:.................+/- 1 dB
Sensitivity (for full output):
   Phono:...........................................................2.2 mV
   Aux/TV/Tape In:..................................................160 mV
Tape Output Level:
   Phono:...........................................................140 mV
   Aux/TV/Tape In:..................................................140 mV
Signal-to-Noise Ratio:
   Phono:............................................................83 dB
   Aux/TV/Tape In:...................................................86 dB
High Filter:.....................................- 6 dB/Octave above 6 kHz
Max. Input Signal at 0.5% THD:
   Phono:...........................................................175 mV
Loudness Contour ch. at:
   100 Hz:...........................................................+6 dB
   10 kHz:.........................................................+4.5 dB
Tone Control Action:
   Bass at 100 Hz:................................................+/-10 dB
   Treble at 10 kHz:..............................................+/-10 dB
Tape Out Level (DIN) (U. K. and Australian models only):............3.3 mv

FM TUNER

Sensitivity (IHF):....................................1.7 microV (9.8 dBf)
Limiting Sensitivity (-3 dB):...................................1.5 microv
Signal-to-Noise Ratio (1 mV)(IHF, A weighted):.......................78 dB
Total Harmonic Distortion (Stereo):..................................0.15%
Stereo Separation (1 kHz):...........................................48 dB
Image Response:......................................................60 dB
IF Response:.........................................................90 dB
Alternate Channel Selectivity:.......................................65 dB
Capture Ratio:......................................................1.0 dB

AM TUNER

Terminal Sensitivity:..............................10 microV for 20 dB S/N
Radiated Sensitivity:.........................................250 microV/m
Image Rejection:.....................................................45 dB
Signal-to-Noise Ratio:...............................................43 dB
Total Harmonic Distortion:...................................0.8% (5 mV/m)
A. G. C. Figure of Merit:............................................50 dB
Selectivity (10 kHz):................................................28 dB
RF Interference Rejection:.................................Rated excellent
Dimensions (Width x Height x Depth):............18 1/2" x 4 1/3" x 10 3/4"
                                                        470 x 110 x 272 mm

ANTENNAS

AM:.......................................................Built-in ferrite
FM:.........................Linecord, plus terminals for External Antennas

POWER REQUIREMENTS

120 V AC, 60 Hz (450 watts max.)
(240 V AC, 50 Hz for U. K. and Australian models -- available in
U.K./Australia only.)


Specifications are typical; individual units might vary.  Specifications
are subjected to change without notice.


(IR-06/25/96)