PRO-100 Infrared Headphones
(330-1145)                   Hints and Tips           Faxback Doc. # 33749


There are two LEDs on the transmitter--one for Charge indicator and the
other for Level indicator

The use of the Audio Level Indicator is explained in the operation of the
PRO-100 (also in Faxback Doc. # 16038) in the steps below:

1..  Turn on the audio source.

2.  Adjust the LEVEL control on the back of the transmitter.

    A.  If you connected the transmitter to jacks that are not controlled
        by the audio source's volume control, rotate LEVEL all the way to
        the right.  Then slowly adjust the LEVEL to the left until the
        AUDIO LEVEL indicator just starts to flicker (***this refers to
        the light on the transmitter***).
    
    B.  If you connected the transmitter to a headphone jack or to jacks
        that are controlled by the audio source's volume control, set the
        system's volume control to about 1/3rd of the maximum and rotate
        LEVEL all the way to the left.  Then slowly adjust LEVEL until the
        AUDIO LEVEL indicator just starts to flicker.

    NOTE:  Some audio sources might not make the AUDIO LEVEL indicator
           flicker.  For these sources, rotate LEVEL all the way to the
           left.
3.  Rotate VOL on the headset to the minimum position.

4.  Set the headphone's ON/OFF switch to  ON and rotate TUN until the
    stereo indocator on the right earcup light. (***Refer to earcup
    indicator light***).

5.  Put on the headphoines.  If necessary, slide the earcups up or down to
    adjust the headband to fit your head.

6.  Slowly rotate VOL on the headset to a comfortable listening level.


(IR-07/17/96)