Optimus XTS-10 Swivel Speaker System
(400-2078)                 Connections                Faxback Doc. # 33894

With the speakers placed in the selected locations, route the speaker wire
from each speaker to the receiver/amplifier.

NOTE:  Use 18-gauge speaker wire for distances up to 25 feet.  For greater
       distance, use 16-gauge wire. Your local Radio Shack store has a wide
       selection of speaker wire.

Follow these steps to connect the speakers to your receiver/amplifier.

1.  Separate the conductors for a length of about 2 inches on each end.

2.  Strip 1/2 inch of insulation from the end of each conductor, then twist
    each end.

3.  Press the right speaker's red (positive) terminal tab and insert the
    marked conductor into the opening, then release the tab.

    NOTE:  Improper phasing can decrease bass sounds.  To help you connect
           speaker terminals in proper phase (+ to + and - to -), one
           conductor of each pair of wires is marked with a stripe or
           groove.  Some wire's insulation is clear, and the wires are
           different colors.

4.  Press the right speaker's black (negative) terminal tab and insert the
    other conductor into the opening, then release the tab.

5.  Insert the other end of the marked conductor into your receiver/
    amplifier's right positive terminal.

6.  Connect the remaining conductor to the receiver/amplifier's right
    negative terminal.

7.  Repeat these steps for the left speaker.

(YO/EB 6/19/96)