SCP-47  (140-1087)               Operation             Faxback Doc. # 9691

Follow these steps to use the radio.

Warning:  To protect your hearing, set the volume controls to their lowest
          settings before you turn on the radio.

1.  Connect the headphones or speakers to the SCP-47.

2.  Set TAPE/RADIO to RADIO.

3.  Set FM ST/FM/AM for the desired band.  Set it to FM ST for stereo
    sound on FM stations.

4.  Adjust L/R VOLUME controls to a comfortable listening level. 

5.  Turn TUNING to select the desired radio station.

Notes:  For best FM reception, fully uncoil the headphone's (or speaker's)
        cord.

        The AM antenna is built-in.  Move the SCP-47 to improve AM
        reception.

        To improve reception for weak FM stereo stations, set FM ST/FM/AM
        to FM.  To return to stereo sound, set it to FM ST.

To turn off the radio, set TAPE/RADIO to TAPE (RADIO OFF).

CASSETTE TAPE PLAYER OPERATION

LOADING A CASSETTE TAPE

Follow these steps to load a cassette tape.

1.  Take up any slack in the cassette tape by turning the hub with a
    pencil.  If you do not remove excess slack, the tape might become
    tangled in the record/play mechanism.  Avoid touching the tape.

2.  Pull open the cassette compartment door.

3.  Insert a cassette tape into the cassette guides so the open edge
    faces up and the full reel is toward the volume control.

4.  Close the cassette compartment door.

PLAYING A CASSETTE TAPE

Follow these steps to play a cassette tape.

Warning:  To protect your hearing, set the volume control to its lowest
          setting before you play the tape.

1.  Load a cassette tape.

2.  Connect headphones or speakers to the (HEADPHONES SYMBOL) jack.

3. Set TAPE/RADIO to TAPE (RADIO OFF).

4.  Press PLAY.

5.  Adjust L/R VOLUME controls to a comfortable listening level.

To fast-forward the cassette tape, press FAST-F.  The button locks, PLAY
releases, and the tape fast-forwards until it reaches the end of the tape
or until you press STOP.

To rewind the cassette tape, you must turn the cassette over and fast-
forward the other side of the tape.  Then, re-insert the cassette for the
side you want to play.

To stop play, press STOP.

USING ANOTHER POWER SOURCE

With the proper adapter, you can operate the SCP-47 from an AC outlet or
your vehicle's cigarette-lighter socket.

Using AC Power

To power the SCP-47 from an AC outlet, you need an AC adapter
(not supplied), such as Cat. No. 273-1654.

Caution:  You must use an adapter that supplies 3-volts DC power and
          delivers at least 200 milliamps.  Its center tip must be set to
          negative, and its plug must properly fit the SCP-47's DC 3V
          jack.  Using an adapter that does not meet these specifications
          could damage the SCP-47 or the adapter.

Follow these steps to power the SCP-47 from an AC outlet.

1.  Set the adapter's voltage switch to 3V.

2.  Attach the adapter's black-rimmed barrel plug to the adapter's cord
    to read TIP NEG.

3.  Insert the plug into the SCP-47's DC 3V jack.  This disconnects the
    internal batteries.

4.  Plug the adapter into a standard AC outlet.

Using Your Vehicle's Cigarette-Lighter Socket

You can power the SCP-47 from your vehicle's cigarette-lighter socket.
This connection requires a DC adapter, such as Cat. No. 270-1560A.

Cautions:  The vehicle must have a 12-volt DC, negative-ground electrical
           system.

           To protect the vehicle's electrical system, always plug the
           adapter into the SCP-47 before you plug it into the cigarette-
           lighter socket.  Always unplug the adapter from the cigarette-
           lighter socket before you unplug it from the SCP-47.

           You must use an adapter that supplies 3-volts DC power and
           delivers at least 200 milliamps.  Its center tip must be set to
           negative, and its plug must properly fit the SCP-47's DC 3V
           jack.  Using an adapter that does not meet these specifications
           could damage the SCP-47 or the adapter.

Follow these steps to power the SCP-47 from your vehicle's
cigarette-lighter socket.

1.  Set the adapter's voltage switch to 3V.

2.  Attach the orange-rimmed barrel plug to the DC adapter's cord to
    read TIP NEG.

3.  Insert the plug into the SCP-47's DC 3V jack.  This disconnects the
    internal batteries.

4.  Plug the adapter into the vehicle's cigarette-lighter socket.

(br/all-02/23/95)