SCP-63  (140-1203)             Installation            Faxback Doc. # 9835

INSTALLING/REPLACING BATTERIES

1.  Slide the battery compartment cover in the direction of the arrow
    marked on it, and lift up on the cover's outer edge.

2.  Install 2 AA batteries, matching the polarity symbols (+ and -).  We
    recommend alkaline batteries, such as Radio Shack Cat. No. 23-552.

3.  Replace the battery compartment cover.

Notes:  Never mix battery types (old and new, alkaline and carbon zinc,
        rechargeable and non-rechargeable).

        Replace both batteries at the same time.

        If the player is not going to be used for a week or more, remove
        the batteries to avoid damage if they leak.

USING HEADPHONES

Before connecting the headphones, turn VOLUME to its lowest setting.  Then
plug the headphones into the HEADPHONES jack.  Your local Radio Shack
store has a complete line of headphones to choose from.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

    Do not listen at extremely high volume levels.  Extended high volume
    listening can lead to permanent hearing loss.

    Set the volume to its lowest level before you begin listening.  After
    you put on the headphones, adjust the volume to a comfortable
    listening level.

    Do not increase the volume once you have established a comfortable
    listening level.  Over time your ears adapt to the listening level,
    so a volume level that does not cause discomfort might still damage
    your hearing.

Traffic Safety 

Do not wear headphones while operating a motor vehicle or riding a
bicycle.  This can cause a traffic hazard and is illegal in some areas.

Even though some headphones are designed to let you hear outside sounds
when you listen at normal volume levels, they still present a traffic
hazard.

USING THE BELT CLIP

For hands-free carrying, slide the belt clip over your belt.  To attach
the belt clip, place it in the recessed area and slide it in the direction
opposite the arrow on the clip until it snaps into place.

To remove the belt clip, press down on the arrow and slide the clip in the
direction of the arrow.

(br/all-02/28/95)