SCP-52  (140-1092)              Operation              Faxback Doc. # 9850

LOADING/UNLOADING A CASSETTE TAPE

Follow these steps to load a cassette tape.

1.  Take up any slack in the tape by turning the cassette's hub with a
    pencil.  Do not touch the exposed tape.

2.  Pull open the cassette compartment door.

3.  With its open edge facing out, insert the cassette tape into the
    cassette guides.  Be sure the side you want to play first faces you
    and the tape's full reel is to the right.

4.  Close the compartment door.

To unload a cassette tape, press STOP to stop playback.  Then open the
cassette compartment door and slide out the cassette tape.

PLAYING A CASSETTE TAPE

Warning:  To prevent possible hearing loss, turn VOLUME to its lowest
          settings before you put on headphones or connect speakers.
          After you connect headphones or speakers, adjust the volume.

1.  Connect headphones or amplified speakers to the HEADPHONE jack.

2.  Load a cassette tape into the cassette compartment.  See "Loading a
    Cassette Tape."

    Note:  If necessary to rewind the tape to the beginning, always press
           <<- or ->> in the direction opposite to the current <<- or ->>
           setting.

3.  Set DIRECTION to left or right, as desired.

4.  Press PLAY.  The tape plays.

    Note:  You cannot select the direction of playback with the PLAY
           button.  The arrows on the PLAY button only indicate that the
           cassette player can play a tape in either direction.

5.  Adjust VOLUME to a comfortable level.

6.  Set E-BASS to IN for an enhanced-bass effect.  Set it to OUT for
    normal bass sound.

7.  If you want to change the tape-play direction, set DIRECTION to its
    other position.

8.  The entire cassette tape repeatedly plays.  To stop playback, press
    STOP.

USING FAST-FORWARD AND REWIND

To fast-forward or rewind the tape, press <<- or ->>.  The following table
shows which button to press, based on the current DIRECTION setting.

When the cassette player reaches the desired segment of the tape, press
STOP.  The tape automatically stops when it reaches the end.  To resume
playback, set direction as desired and press PLAY.

USING THE BELT CLIP

For hands-free carrying, slide the belt clip over your belt.
To remove the belt clip, press down on the arrow and slide the clip in the
direction of the arrow.

To replace the belt clip, place it in the recessed area and slide it in
the opposite direction of the arrow until it snaps into place.

(br/all-02/28/95)