SCP-51  (140-1091)              Installation           Faxback Doc. # 9859

BATTERY OPERATION

1.  Press down on the battery compartment cover and slide it off.

2.  Install 2 AA batteries, matching the polarity symbols (+ and -)
    marked on the diagram beside the battery compartment.  We recommend
    alkaline batteries, such as Radio Shack Cat. No. 23-552.

3.  Replace the battery compartment cover.

    Notes:  Never mix battery types (old and new, alkaline and carbon
            zinc, rechargeable and non-rechargeable).

           Replace both batteries at the same time.

            If the player is not going to be used for a week or more,
            remove the batteries to avoid possible damage from leaking
            batteries.

USING HEADPHONES

Before connecting the headphones, turn VOLUME to its lowest setting.  Then
plug the headphones into the PHONES (HEADPHONE SYMBOL) jack.  Adjust
VOLUME to a comfortable listening level.  Your local Radio Shack store has
a complete line of headphones to choose from.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

Do not listen at extremely high volume levels.  Extended high volume
listening can lead to permanent hearing loss.

Set the volume to its lowest level before you begin listening.  After you
put on the headphones, adjust the volume to a comfortable listening level.

Do not increase the volume once you have established a comfortable
listening level.  Over time your ears adapt to the listening level, so a
volume level that does not cause discomfort might still damage your
hearing.

Traffic Safety

Do not wear headphones while operating a motor vehicle or riding a
bicycle.  This can cause a traffic hazard and is illegal in some areas.
Even though some headphones are designed to let you hear outside sounds
when you listen at normal volume levels, they still present a traffic
hazard.

USING THE BELT CLIP

For hands-free carrying, slide the belt clip over your belt.

To remove the belt clip, press down on the arrow and slide the clip in the
direction of the arrow.

To replace the belt clip, place it in the recessed area and slide it in
the opposite direction of the arrow until it snaps into place.

(br/all-02/28/95)