SCT-54  (140-0673)              Installation           Faxback Doc. # 9920

Connecting the Recording and Playback Cables

1.  Using one of the supplied audio cables, connect the cassette deck's
    left and right LINE OUTPUT jacks to the receiver/amplifier's left
    and right tape input jacks.

2.  Using the other audio cable, connect the cassette deck's LINE INPUT
    jacks to the receiver/amplifier's tape output jacks.

Note:  If you are not sure which receiver/amplifier jacks to use, refer
       to your receiver/amplifier's owner's manual.

Connecting the Remote Control Cable

If you have an Optimus receiver/amplifier that has a remote control jack
(labeled CONTROL IN/OUT), you can use the receiver/amplifier's control to
operate the cassette deck.

Connect the receiver/amplifier's CONTROL OUT jack to the cassette deck's
CONTROL IN jack using the supplied remote control cable.

If you have an another Optimus audio component that has a remote control
jack, connect the cassette deck's CONTROL OUT jack to the component's
CONTROL IN jack.  This relays the remote control signal from the receiver/
amplifier to the other component.

Connecting the CD-Deck Synchro Control Cable

If you have an Optimus CD player that has a CD-DECK SYNCHRO control jack,
connect the jack to your cassette deck's CD-DECK SYNCHRO control jack using
the supplied CD-deck synchro control cable.  This connection lets
you easily make CD-to-cassette deck recordings.  See "CD-Deck Synchro 
Recording."

Connecting Power

Carefully check all connections.  Then plug the AC power cord into a
standard AC outlet.  The power cord's plug is polarized and fits only
one way.  The cassette deck automatically turns on.

Warning:  To prevent electric shock, do not plug the power cord into an
          extension cord or other receptacle unless you can fully and
          easily insert the plug's blades.

(LB/all-03/01/95)