CTR-94  (140-0726)              Operation              Faxback Doc. # 9929

Warning:  To protect your hearing, set VOLUME to its lowest setting before
          you turn on the radio.  After the radio begins to play, adjust
          the volume to a comfortable listening level.

1.  Set FUNCTION to FM or AM to turn on the radio to the desired band.

2.  Adjust TUNING to the desired station.

    Notes:  The AM antenna is built-in.  For the best AM reception, rotate
            the CTR-94.

            For the best FM reception, fully extend the telescoping
            antenna and swivel it to the position that produces the best
            reception.

3.  Adjust VOLUME to a comfortable listening level.

4.  Set BASS to its up position for normal bass sound or to its down
    position to enhance the low frequency sounds.

5.  Set FUNCTION to TAPE/RADIO OFF to turn off the radio.

CASSETTE PLAYER OPERATION

LOADING A CASSETTE TAPE

Cautions:  Take up any slack in the tape by turning the hub with a pencil.
           If you do not remove excess slack, the tape might become
           tangled in the record/playback mechanism.

           Avoid touching the tape.  Fingerprints attract dust and dirt.

1.  Press STOP/EJECT to open the cassette compartment cover.

2.  Load the cassette with its open edge facing up.

    Note:  To hear the entire tape, be sure the tape's full reel is on the
           right.  If necessary, press REWIND to rewind the tape.  The
           deck automatically stops when it completely rewinds the tape.

3.  Gently close the compartment.

PLAYING A CASSETTE TAPE

Warning:  To protect your hearing, set VOLUME to its lowest setting before
          you begin playing a cassette tape.  After the tape begins to
          play, adjust the volume to a comfortable listening level.

1.  Set FUNCTION to TAPE/RADIO OFF.

2.  Load a cassette tape.

3.  Press PLAY.  The tape player plays the cassette tape until it reaches
    the end, then it automatically stops.

    Note:  Press PAUSE to temporarily stop tape play.  Press PAUSE again
           to resume play.

4.  Adjust VOLUME to the desired listening level.

5.  Set BASS to its up position for normal bass sound or to its down
    position to enhance the low frequency sounds.

6.  Press FAST.F. or REWIND to rapidly wind the tape forward or backward. 
    Press PLAY again to resume play.

    Note:  The cassette deck automatically stops at the end of the tape
           during fast-forward or rewind.

7.  Press STOP/EJECT to completely stop tape playback before it
    automatically stops.  Press STOP/EJECT while the cassette player is
    stopped to open the cassette compartment and remove the cassette
    tape.

    Notes:  To play a tape's other side, you must remove the cassette,
            turn it over, re-insert it, then press PLAY again.

            Always remove and store cassette tapes when you are not
            using them.

RECORDING

You can record from the radio, or use the built-in microphone to make a
live recording.

Notes:  Before you load a cassette tape for recording, be sure the erase-
        protection tabs are in place on the cassette tape you are
        recording onto.

        Before you load a cassette tape for recording, turn the cassette's
        hub with your finger or a pencil to move the tape past its leader.

        Tape quality greatly affects the quality of the recording.  We
        recommend extended-range or low noise type 1 regular length (60-
        minute or 90-minute) normal-bias cassette tapes.  Long-play
        cassette tapes such as C-120s are not recommended.

        The CTR-94's Automatic Level Control (ALC) automatically adjusts
        the recording level.  VOLUME has no effect on recording.

Warning:  Do not force down RECORD or you can damage the record mechanism.

Recording from the Radio

1.  Load a blank cassette tape or one you want to record over into the
    cassette compartment.

2.  Set FUNCTION to FM or AM.

3.  Adjust TUNING to the station you want to record.

4.  Press RECORD to begin recording.  Both PLAY and RECORD lock down.

5.  Press STOP/EJECT to stop recording.

    Notes:  To temporarily stop recording, press PAUSE.

            Recording automatically stops when the tape reaches its end.
            To record on the other side, turn over the tape.

Making Live Recordings

Follow these steps to make live recordings using the built-in microphone.

1.  Set FUNCTION to TAPE/RADIO OFF.

2.  Load a blank cassette tape or one you want to record over into the
    cassette compartment.

3.  Place the CTR-94 2 or 3 feet from the recording source.

4.  Press RECORD to begin recording.  Both PLAY and RECORD lock down.

5.  Press STOP/EJECT to stop recording.

    Note:  The deck automatically stops when the tape reaches the end of
           the side.

(br/all-03/01/95)