85 x 4 4-Channel Trunk Mount Amplifier
(120-1977)                 Addendum                   Faxback Doc. # 16925

On page 17 under "Connecting Two Speakers (Bridged Connection)" shows the
right speaker wires connected incorrectly. 

The procedures on Page 18 are incorrect.  Replace them with the following
Steps.

1.  Connect the two speakers to the CH1 and CH2 terminals (front 
    speakers)

2.  for an unbridged connection, connect the subwoofer to the amplifier's
    CH3 and CH4 terminals.

3.  Push in X-OVER FREQ so you can later adjust the amplifier's sound to
    compensate for your vehicle's acoustics (see "Using the Frequency 
    Crossover").

4.  Press and release the left and right BRG/ST (Bridged/Stereo) switches 
    to make sure they are at ST (Stereo) position.

The procedures on Page 19 are incorrect.  Replace them with the following
Steps.

1.  Connect the two speakers to the CH1 and CH2 terminals (front
    speakers).

2.  For a bridged connection, connect the subwoofer to the amplifier's
    +CH3 and CH4+ terminals.

3.  Push in X-OVER FREQ so you can later adjust the amplifier's sound to
    compensate for your vehicle's acoustics (see "Using the Frequency 
    Crossover").

4.  Press and release the right BRG/ST (Bridged/Stereo) switch to make 
    sure it is at ST (Stereo) position.

5.  Push in the left BRG/ST (Bridged/Stereo) switch to the BRG position 
    to bridge the rear speakers (CH3 and CH4)