4 x 25 Watt Trunk Mount Amplifier
(120-1976)                   Operation                Faxback Doc. # 16985

TURNING ON THE AMPLIFIER

The amplifier automatically turns on whenever you turn on your autosound
system.  POWER lights when the amplifier is operating.

SETTING THE LEVEL CONTROL

For the best performance, you can adjust the level of the audio signals 
that enter the amplifier by following these steps.

CAUTIONS:  The sound distorts if any output channel shorts.  Turn off the
           amplifier and try to locate the short.

           To prevent draining the vehicle's battery, do not play the
           amplifier for too long using the ignition switch's ACC position
           after turning off the vehicle's ignition.

1.  Using a flat blade screwdriver, turn both LEVEL MIN/MAX controls fully
    counterclockwise to MIN.

    Note:  The right level control is for the front speakers; the left
           level control is for the rear speakers.

2.  Temporarily turn up the autosound system's volume control to about
    one-third of its full range.

    Caution:  Never turn the level controls up any farther than you need
              to get clear sound at two thirds volume maximum.

3.  Turn either the left or right LEVEL control clockwise until you can
    hear the sound at a comfortable level.

4.  Turn up the volume on you autosound system until the sound begins
    to distort.  Then immediately turn down the volume to the point 
    just below where distortion began.

5.  Adjust the level controls until the volume is at the maximum level
    you want the autosound system to produce.

6.  Adjust the autosound system's volume control to a comfortable
    listening level.