High Power AM/FM Stereo Car Cassette Player
(120-2104A)                Operation                  Faxback Doc. # 18187

SETTING THE CLOCK

1.  Turn on the vehicle's ignition.

2.  Press POWER to turn off the radio.  The currently set time appears on
    the display.

    NOTES:  You can set the time only when the radio is turned off and the 
            vehicle's ignition is turned on or set to ACC.

            If you do not perform Steps 3-6 within 5 seconds of each other,
            the hour stops flashing and the display returns to the current
            time.

3.  Press and hold F/C until the hour flashes, then release F/C.

4.  Press /\ to increase, or \/ to decrease the hour to the desired time.

5.  Press F/C again until the minutes flash.

6.  Press /\ to increase, or \/ to decrease the minutes to the desired
    time.

SELECTING THE DISPLAY COLOR

The display and front panel lighting can be switched to green or amber.  To
change the display's color, do the following:

1.  Remove the front panel to expose the lighting selector switch.  See
    "Attaching and Removing the Front Panel," Faxback Doc.#      ,
    Installation.

2.  Slide the selector switch to the desired color.

3.  Replace the front panel and turn on the stereo.  The display and front
    panel show the color you selected.

UNDERSTANDING THE CONTROLS

When you listen to your stereo, you can adjust the following controls to
suit your listening preferences.

On/Off - Press POWER to turn the stereo on or off.

Volume - Press /\ to increase or \/ to decrease the volume.  The volume 
         level appears on the display (such as VOL:50).  The volume level 
         ranges from 0 to 80.

WARNING:  To protect your hearing, do not listen at high volume levels.  
          Slowly increase the volume to a comfortable listening level.

Audio Select - Repeatedly press AUDIO SEL to select the other audio
               controls for adjustment.  The selection sequence is Bass ->
               Treble -> Balance -> Fader -> Volume -> Bass.  The display
               automatically returns to the time display 5 seconds after 
               you finish adjusting the sound.

Bass - Press AUDIO SEL until the display shows the current bass level
       (such as BAS:+2).  Then press /\ to increase or \/ to decrease
       the low-frequency sounds.  The base level ranges from +7 to -7.

Treble - Press AUDIO SEL until the display shows the current treble level
         (such as TRE:--2).  Then press /\ to increase or \/ to decrease
         the high-frequency sounds.  The treble level ranges from +7 or -7.

Balance - Press AUDIO SEL until the display shows the current balance level
          (such as BAL:L2).  Then press /\ to shift the balance to the
          right speakers, or press \/ to shift the balance to the left
          speakers.  The balance level ranges from L9 to R9.

Fader - Press AUDIO SEL until the display shows the current fader level 
        (such as FAD:F2).  Then press /\ to shift the balance to the rear
        speakers, or press \/ to shift the balance to the front speakers.
        The fader level ranges from F9 to R9.

NOTE:  If you have only one pair of speakers and you are also using the
       line-level outputs, then the fader control adjusts the balance
       between the speakers and the line-level outputs.  R indicates
       more output to the line-level outputs and F indicates more output
       to the speaker wires.

Mute - Press MUTE to temporarily silence the sound.  The display shows
       - - - - -.  Press MUTE again to restore the sound.

Loudness - Press LOUD to boost the high and low frequencies when listening
           at low volume levels.  LOUD appears on the display.  Press LOUD
           again to return to normal listening.


(CS 11/20/95)