Modulaire 8 Stereo Receiver System
(120-1487)                 Installation               Faxback Doc. # 18733

VENTILATION

The output transistors of the Modulaire 8 are operated conservatively for
maximum frequency response, low heat dissipation and long life.  It is
therefore not essential to observe special precautions when installing the
control center.  Merely allow two to three inches behind the control
center when installing into a closet or bookshelf.

POWER REQUIREMENTS

Connect the AC line cord into any outlet furnishing 117 volts 60 cycles
AC current.

SPEAKER CONNECTIONS

For your convenience, we have provided RCA plug-type connectors on the
rear panel for quick, trouble-free speaker connections.  To connect your
speakers, simply plug them into the receptacles marked speakers.  Two
prepared speaker cables are supplied with your REALISTIC system with a
phono plug connector at each end for this simple plug-in connection to
your unit.  (Please refer to the diagrams supplied in this instruction
manual which indicate the exact location of these speaker connection
receptacles.)

CONNECTING THE SPEAKERS FOR STEREO

OPERATION

1.  Plug one end of the speaker cable into the receptacle on the rear of
    your left speaker.  (This is the speaker on the left as you face the
    speakers.)

2.  Plug the other end of the speaker cable into the LEFT speaker
    receptacle on the rear of the system.

3.  Similarly, connect the other speaker cable to your right speaker.

4.  Attach the other end of the speaker cable to the receptacle marked
    RIGHT on the rear of the system.

5.  Your music system is now connected for stereo operation.

NOTE:  The speaker cables may be dressed in any convenient location;
       however, should you staple wires in place, take care not to drive
       the staples through the center of the wire, for this may short out
       the cable and will decrease the overall volume or short out the
       speakers entirely.


(br/SP-12/28/95)