3000 NL  (250-4072)            Floppy Drive             Faxback Doc. # 1427

If you are adding a 3 1/2-inch diskette drive:

1. Remove the appropriate plastic panel from the front of the computer
   cover.
2. Consult the documentation provided with your drive to determine which
   set of mounting holes in the drive platform to use.
3. Locate the data cable in your computer, and attach it to the 
   corresponding connector of your drive.
4. Using the corresponding mounting holes selected in Step 2, mount the 
   drive in the computer.

If you are adding a 5 1.4-inch diskette drive:

1. Remove the appropriate plastic panel from the front of the computer 
   cover.
2. Remove both pairs of drive mounting rails from the inside of the drive
   tower by pressing them toward each other and sliding them forward out of
   the tower.
3. Unscrew the grounding clip from each mounting rail. Discard the screws.
4. Consult the documentation provided with your drive to determine which
   set of rail holes to use to mount the rails on the drive.
5. Replace the grounding clips, and attach the appropriate pair of mounting
   rails to your drive using screws in the drive installation screw kit
   (provided).
6. Locate the power connector wire in the computer, and attach it to the
   power connector of your drive.
7. Locate the data cable in your computer, and attach it to the data
   connector of your drive.
8. Using the corresponding mounting slots located inside the drive tower,
   slide the drive into the computer.

(/tmc-05/01/95)