2500 SX/33  
(250-1623)             Dual Voltage Power Supply      Faxback Doc. # 1736

Your computer can be set for use with 110-120V, grounded AC outlet or a 
220-240V, grounded outlet. Before connecting the computer cables, check the
back of the computer. The voltage written on this label must match the
voltage of the outlet you will be using.

If the label does not match the outlet, change the setting of the red
voltage selector switch inside the computer. 

The switch is located under the carriage, near the back panel, on the power
supply. Position the switch so that the voltage you will be using is
visible.

         ┌──────────┐         ┌──────────┐
         │┌────────┐│         │┌────────┐│
         ││  115V  ││         ││        ││
         │├────────┤│         ││        ││
         ││        ││         │├────────┤│
         ││        ││         ││  230V  ││
         │└────────┘│         │└────────┘│
         └──────────┘         └──────────┘

After checking the voltage selector switch setting, connect all cables.
Depending on the monitor you install, a small flat-head screwdriver might 
be required to secure the monitor cable connector to the video connector 
on the computer.

Connect the power cord to an AC outlet after reading the following 
information:

° Do not use an outlet that powers heavy machinery. If you must use an 
  extension cord, use a grounded one with multiple outlets.

° For units set at 115V: Use a UL-Listed cord set consisting of a minimum 
  18 AWG, type SVT or SJT three-conductor cord a maximum of 15 feet in 
  length and a parallel blade, grounding-type attachment plug rated 10 A, 
  125V.

Note: The power cord included with the computer meets these requirements.

° For units set at 230V inside U.S.A.: Use a cord set consisting of a
  minimum 18 AWG, type SVT or SJT three-conductor cord a maximum of 15 feet
  in length and a tandem blade, grounding type attachment plug rated 10 A,
  250V.

° For units set at 230V outside U.S.A: Use a cord set consisting of a
  minimum 0.75 mm cord and a grounding-type attachment plug rated 10 A,
  250V. The cord set should have the appropriate safety approvals for the
  country in which the equipment will be installed and should be marked 
  HAR.

(/tmc-09/11/95)