TANDY 2500 RSX  (250-1620/1621)   Windows Video Drivers  Faxback Doc.# 1892

If you install Microsoft Windows 3.1 on your computer, you may want to
change the video display mode. To do this, follow these steps:

Note: These instructions are also found in the README file on the Utilities
Disk.

1. Change to the \WINDOWS subdirectory.
2. From the MS-DOS command line, type setup and press <ENTER>.
3. When the Windows SETUP program appears, select the Display field, and
   press <ENTER>.
4. Select Other from the list, and press <ENTER>.
5. Insert the Utilities diskette into Drive A.

   When Window prompts you for the hardware manufacturer's video driver,
   type:

   a:\win31 <ENTER>.

   The following video options are displayed:

   AVGA2  1024X768, 16 colors  (1,2)
   AVGA2   640x480, 256 colors (2)
   AVGA2   800x600, 16 colors  (1)
   AVGA2   800x600, 256 colors (1,2)

(1) Requires a multiple-frequency monitor.
(2) Requires additional video memory.

Select one of these options and press <ENTER>. Press <ENTER> again to 
accept the changes.

Windows setup prompts you to enter various Windows 3.1 diskettes. Insert 
the appropriate diskettes. After Windows setup prompts you for the 
Utilities diskette, insert disk and type:

 a:\wind31  <ENTER>.

Windows runs in the selected resolution.

Note: If you want to change the resolution again, you can use the Windows
SETUP icon to run SETUP from Windows instead of running it from MS-DOS.

(/tmc-08/30/95)