IBM Aptiva M51/M53/M71/M63/A40/A90/M55/A50/A12/A14/A10 (250-0440/43/44/45/50/51/52/53/54/55/61) Restoration Faxback Doc. # 18176 Installing the entire software preload on the Aptiva Windows 95 System First, you may need to create the recovery diskette. To do this click on Start. Then in order, click on Programs, Accessories, System Tools, and Recovery Diskette. You will be prompted to insert a diskette. After inserting the diskette, press . The recovery diskette will be created. You will see a message that the operation has completed. The following is the procedure for installing the entire software load from the Product Recovery CD: Boot with the Windows 95 recovery diskette. This will give message of "Do you wish to update the Aptiva software on your hard disk (Y/N) ? Type "Y". Next, a disclaimer will appear and ask if you accept. Type "Y". You will then see the warning for the format. If you type "Y", the customer will LOSE ALL DATA ! Be certain the customer has backed up any programs or data they need to keep before you continue, and that the customer knows they will need to reload their third party applications. **NOTE** An answer of "N" each time will take you to an A:\> prompt. After a Quick Format, all of the Windows 95 system directories will be created. Then the files will be inflated. When the inflating is done, you will prompted to reboot without the disk. This will launch the WIN95 setup program. During this process you will be prompted to enter name & company, to accept the license agreement and insert the Certificate of Authenticity number (which is located on the intro. manual). At this point the WIN95 setup will analyze the hardware installed on the system. A progress bar will be displayed. After Step #11 is complete, you will be prompted to restart. Click "OK". During this phase, WIN95 will update the configuration files, run the Aptiva setup, Autoplay, MS Exchange, Setup Printer, Time Zone, and the IBM Mwave. At this point, the system will reboot again into the WIN95 Welcome. (CD/BKL-03/13/96)