Packard Bell  (250-0304)         Memory Upgrade         Faxback Doc. # 3751
Statesman 200C

The memory board contains six, 18-pin connectors; two for each memory
module.  To install memory:

1.  Make sure the computer is configured for on/off mode and is powered
    off.

2.  Disconnect the AC adapter and remove the battery pack.

3.  Remove the memory access panel cover.

4.  Orient the connectors on the first memory module to align with the two
    sockets labeled CN501 and CN502.

5.  Press the module firmly into the connectors until it is firmly seated.

    If a second module is being installed, insert it into CN503 and CN504;
    a third module is inserted into CN505 and CN506.

6.  Reinstall the memory cover.

7.  Use SETUP to correct the amount of memory set in the system.


(br/all-04/14/95)