IBM Aptiva Axx/Mxx Setup Faxback Doc. # 34618 Press F! when it is displayed on the computer screen during boot up to go into the setup program. IBM Aptiva (A90) Computer Setup Information --------------------------------------------------------------------------- Main Menu Screen IBM SurePath Setup Utility Main Menu Select a Menu ° System Information ° Video and Monitor ° Disk Drives ° Input/Output Ports ° Rapid Resume ° Plug and Play ° Startup Options ° Model Information ° Date and Time ° Advanced Options Help General Help Load Factory Settings Exit Setup (Up and down arrows) Move View Menu --------------------------------------------------------------------------- System Information Screen IBM SurePath Setup Utility System Information Processor Pentium Processor Speed 166 MHz Math Coprocessor Internal System Memory 16834 KB Memory Type Non-parity Cache Size 0 KB Video Memory 1024 KB Diskette Drive A: 1.44 MB 3.5" Diskette Drive B: Not installed Hard Disk Drive 1 1707 MB Hard Disk Drive 2 Not installed CD-ROM Drive 3 Installed Hard Disk Drive 4 Not installed Serial Port A 3E8h-IRQ 4 Serial Port B 2F8h-IRQ 3 Parallel Port 3BCh Mouse Installed General Help Previous Menu --------------------------------------------------------------------------- Video and Monitor Screen IBM SurePath Setup Utility Video and Monitor Video Controller Trident TGUI96xx Video Memory 1024 KB Monitor Setup [Plug and Play / DDC] (Other choices: Set Refresh Rate Set Frequency) Monitor Horizontal Frequency[Not Used ] (Other Choices with Set Frequency chosen: Undefined 31.5 KHz (VGA) 31.5 - 36.9 KHz 37.0 - 37.9 KHz 38.0 - 48.9 KHz 49.0 - 59.9 KHz 60.0 - 67.9 KHz 68.0 - 78.9 KHz 79.0 - 89.9 KHz 90.0 - 95.0 KHz ) (Refresh Rates will change automatically based upon the frequency chosen.) Refresh Rates (with Plug and Play / DDC chosen in Setup) 640 x 480 Resolution [60 Hz] 800 x 600 Resolution [Not Supported] 1024 x 768 Resolution [Not Supported] 1280 x 1024 Resolution [Not Supported] 1600 x 1200 Resolution [Not Supported] (Other choices with Set Refresh Rates chosen) 640 x 480 Resolution [60,72,75,85 Hz] 800 x 600 Resolution [Not Supported, 60,75,85 Hz] 1024 x 768 Resolution [Not Supported, 87 Hz interlaced,60 Hz 70 Hz, 75Hz] 1280 x 1024 Resolution [Not Supported, 87 Hz intrlaced,60 Hz] 1600 x 1200 Resolution [Not Supported, 96 Hz Interlaced] Help General Help Next Value Previous Menu Move Previous Value --------------------------------------------------------------------------- Disk Drives Screen IBM SurePath Setup Utility Disk Drives Diskette Drive A: [1.44 MB 3.5"] Diskette Drive B: [Not Installed} (Other disk drive choices: Not Installed, 360 KB 5.25", 1.2 MB 5.25", 1.44 MB 3.5", 2.88 MB 3.5") . Hard Disk Drive 1 . Hard Disk Drive 2 . CD-ROM Drive 3 . Hard Disk Drive 4 Help General Help Move Previous Menu View Menu --------------------------------------------------------------------------- (Since "." in front of Hard Disk area has a submenu option.) Example: Hard Disk Drive 1 Size 1707 MB Local Bus IDE Mode [High Performance] (Other choice: Compatible {will gray out Read Prefetch if chosen}) Read Prefetch [Disabled] (Other choice: Enabled) Disk BIOS Translation [Enabled] (Other choice: Disabled) Parameter Table Type [Enhanced] (Other Choice, if Disk BIOS Translation is enabled, Standard) CD-ROM Drive 3 Size Installed Local Bus IDE Mode [High Performance] (Other choice: Compatible {will gray out Read Prefetch if chosen}) Read Prefetch [Disabled] (Other choice: Enabled) Help General Help Next Value Previous Menu Move Previous Value --------------------------------------------------------------------------- INPUT/OUTPUT PORTS Serial Port A [3E8h - IRQ 4 ] 2E8h, Disabled Serial Port B [2F8h - IRQ 3 ] 2E8h - IRQ 3, Disabled Parallel Port [3BCh ] 378h, 278h, Disabled Parallel Port Mode [compatible ] PS/2 Bidirectional, ECP * note - compatible is normal - other modes are bidirectional. Mouse [ Installed ] Not installed Keyboard NumLock State [ ON] Off Keyboard Speed [ Fast ] Mwave Adapter [Installed] Not Installed Help General Help Next Value Previous Menu Move Previous Value ___________________________________________________________________________ RAPID RESUME APM BIOS Mode [ 32 Bit Protected ] 16 and 32 Bit, Disabled, Real Mode Only, 16 Bit Protected Rapid Resume [ Disabled] Enabled ***the following two options are grayed if Rapid Resume is Disabled *** Automatic Power Off [Disabled ] 10, 15, 20, 25, 30, 40, 50, 60, 70, 80, 90, Disabled Initialize Adapter Cards [Disabled] Reload Device Drivers Stand by Timer [15 ] 20, 25, 30, 40, 50, 60, 70, 80, 90, Disabled ***the following option is grayed if Rapid Resume is disabled *** Stand by Snapshot [Disabled] Enabled ***the following three options are grayed if Standy by Timer is Disabled*** Halt CPU when Idle [Enabled] Disable Monitor Mode [VESA Standyby] Lowest Power Blink LED in Standby [Disabled ] Enabled Wake Up on Ring [ Disabled ] Enabled ***the following option is grayed if WAke Up on Ring is Disabled*** Indicator [ Disabled ] Enabled Wake Up on Alarm [ Disabled ] Single Event, Daily Event ***the following two options are grayed if Wake up on Alarm is Disabled *** Alarm Date [05/23/96] Alarm Time [10:53] Help General Help Next Value Previous Menu Move Previous Value ___________________________________________________________________________ PLUG AND PLAY Plug and Play Cards Detected 0 ** will only have options if plug and play card detected ___________________________________________________________________________ STARTUP OPTIONS First Startup Device [Diskette Drive A:] Hard Disk 1, Disabled ***other startup devices are grayed if First Startup Device is Disabled *** Second Startup Device [Hard Disk 1] Disabled *** the Third and Fourth devices are only available if you have a second or third hard drive *** Third Startup Device [Disabled] Fourth Startup Device [Disabled] System Memory Test [ Enabled] Disabled Virus Detection [Enabled ] Disabled ___________________________________________________________________________ MODEL INFORMATION Model Number 2168A40 Serial Number 2331PLB BIOS Version BG2US0J BIOS Date 03/06/96 *** note- this information is particular to your machine*** ___________________________________________________________________________ DATE AND TIME Date [05/29/1996] Time [12:28:08] ___________________________________________________________________________ SECURITY OPTIONS . Power-on Password Diskette Drive Access [Enabled] Disabled Operate without Keyboard [Disabled] Enabled Operate without Diskette Drive(s) [Disabled] Enabled ___________________________________________________________________________ POWER-ON PASSWORD Power-on Password Status Disabled Enter your new Power-on Password twice. The Power-on Password may be up to seven characters long. Enter Power-on Password [ ] Enter Power-on Password Again [ ] Set or Change Power-on Password Delete Power-on Password Password Prompt [On ] Off ___________________________________________________________________________ Change Power-on Password The new Power-on Password will replace the existing Power-on Password. Press to continue ___________________________________________________________________________ Delete Power-on Password The existing Power-on Password will be deleted. Press to continue ___________________________________________________________________________ CACHE OPTIONS F000-FFF (System BIOS) Enabled E800-EFFF (Rapid Resume BIOS) Enabled E000-E7FF (System POST) Enabled D800-DFFF (Adapter ROM) [Disabled] Enabled D000-D7FF (Adapter ROM) [Disabled] Enabled C800-CFFF (Adapter ROM) [Disabled] Enabled C000-C7FF (Adapter Video BIOS) [Enabled] Disabled Upper Memory Boundary F400 ___________________________________________________________________________ MEMORY OPTIONS Memory Bank 1 [Standard] EDO Memory Bank 2 [Standard] EDO ___________________________________________________________________________ PCI CARD OPTIONS PCI-1 Card Bus Mastering [Enabled] Disabled PCI-2 Card Bus Mastering [Enabled] Disabled ___________________________________________________________________________ EXIT SETUP UTILITY Do you want to exit the Setup Utility? Yes, Exit the Setup Utility. No, return to the Setup Utility. ___________________________________________________________________________ (DM/JN/BKL-09/17/96)