PRO-2002 AM/FM Scanning Receiver (200-0116) Searching Faxback Doc. # 18977 One great feature of your PRO-2002 is its ability to "search" for frequencies being used on each band. This means you can hear all the action on the airwaves in your area! You can store one Search range in each Bank, giving you a total of five Search ranges you can program. To use this great feature, just follow these steps: 1. Press PROGRAM Key. 2. Select one of the five Bank keys. 3. Press LIMIT Key. Enter the lower limit of the frequency range to be searched (such as 45.00 MHz). Press ENTER. 4. Press LIMIT Key again. Enter the upper limit of the frequency range to be searched (such as 46.00 MHz). Press ENTER. 5. Press either ARROW UP or ARROW DOWN to start Search. ARROW DOWN will start Search from highest frequency and go down while ARROW UP will start from the lowest frequency and go up. 6. You can control the speed of the Search by using the SPEED Key the same way you use it during scanning. 7. Search will stop when a frequency is found with a signal. To re-start Search, press ARROW UP or ARROW DOWN. Storing Frequencies If you want to enter some of the frequencies found during Search, do this: 1. Press MONITOR when you PRO-2002 finds a frequency you want to store. 2. Use MANUAL Key to select a channel to enter the frequency your PRO-2002 found. The Display will show the frequency currently stored on the channel, but don't worry-the old frequency will be erased when you start to enter the new one. 3. Press PROGRAM. 4. Press MONITOR again. The new frequency found during the Search will be displayed. 5. Press ENTER to put the new frequency into the channel in the channel in place of the old frequency. 6. Press either ARROW UP or ARROW DOWN to resume the Search. To return to Manual or Program operation, press MANUAL or PROGRAM. To resume the Search from one of the limit frequencies, press LIMIT and then ARROW UP or ARROW DOWN. (/all-02/14/96)