COMP-100 5-Band FM Scanning Monitor Receiver
(200-0110)                  Operation                 Faxback Doc. # 31131

Programming

1.  Select the channel you want to enter a program frequency by pressing
    the MANUAL button as many times as required to move the light on the
    channel indicators to that desired channel.

2.  Slide the Program Door open and press in the PROGRAM button.  If the 
    Program Indicator lights up, the unit is ready to receive a new
    program.

3.  Find the code from the Code Table to match the frequency you want.
    The numbers tell you which Digit Swittches should be "out" and * marks
    show which digit switches remain "in".

4.  After you have set the code into all 16 Digit Switches, press the
    ENTER button.  The Code Indicators are lighted to reflect the new
    program code for the frequency  entered.

5.  Press the PROGRAM button again to release it (button out).  The
    program light goes out, the code indicator LEDs go out and the only
    light "on" is for the selected channel.

6.  Press all of the Digit Switches in (buttons in).

7.  To enter another program, select a channel and the frequency desired
    and repeat Steps 1 through 5.

8.  After programming,  close the program door, and you are ready to
    receive signals.


(IR-03/07/96)