CB 27 Glass Mount CB Antenna
(210-0985)                 Installation               Faxback Doc. # 33099

MOUNTING THE ANTENNA

Before you mount the antenna, move your vehicle to a shaded location where
the temperature is between 70 and 100 degrees F.  If the vehicle's glass is
too hot or too cold, the antenna's adhesive might not properly set.

1.  Select a location for the antenna.  Typical mounting locations are the
    top center of the front or rear windows.  Be sure the location you
    select:

       Does not block the driver's view

       Does not interfere with windshield wiper operation

       Is not coated with a metal film-type sunscreen

       Is not on a defroster element

       IMPORTANT:  Do not remove the paper backing from the coupler box or
                   antenna base until Step 4.  Once you stick the coupler
                   box or antenna base to the glass, you cannot remove it
                   without damaging it.

2.  Position both the antenna and the coupler box at the desired locations
    to confirm that neither will interfere with your vehicle's normal
    operation.

3.  Use the supplied alcohol wipe to clean the glass at the mounting
    locations.  Allow the glass to dry completely before continuing.

4.  Remove the paper backing from the coupler box and carefully position it
    over the mounting location.  Then firmly press it into place and hold
    it for 5 seconds.

5.  Remove the paper backing from the antenna base and carefully position
    it over the coupler box.  Then firmly press it into place and hold it
    for 5 seconds.

6.  Route the cable to your CB transceiver and follow the transceiver's
    instructions to connect the cable.


(YO/EB 5/14/96)