Wild Boss
(600-4141)                 Installing Batteries       Faxback Doc. # 18392

Your Radio Shack Wild Boss is built to handle the road, whether the road is
the hallway in your house or the sidewalk outside.

NOTE:  You need six AA batteries to power your Wild Boss, and one 9-volt
       battery to power the transmitter.

INSTALLING BATTERIES

CAUTIONS:  Use only fresh batteries of the required size and type.

           Do not mix old and new batteries.

           Never leave dead or weak batteries in the Wild Boss or the
           transmitter.

           If you do not plan to use the Wild Boss for several days,
           remove the batteries.

           Dispose of batteries promptly and properly; do not bury or burn
           them.

Installing the Wild Boss' Batteries

You need six AA batteries to power your Wild Boss.  We recommend alkaline
batteries, such as Radio Shack Cat. No. 23-652.

1.  Set ON/OFF on the back of the Wild Boss to OFF.

2.  Turn the battery compartment cover's latch on the Wild Boss clockwise,
    then lift the cover to remove it.

3.  Install the batteries as indicated by the polarity symbols (+ and-)
    marked inside the compartment.

4.  Replace the battery compartment cover, then turn the latch on the
    cover counterclockwise to secure it.

Installing the Transmitter's Battery

The transmitter uses one 9-volt battery.  We recommend an alkaline
battery, such as Cat. No. 23-553.

1.  While pressing down on the battery compartment cover's tab, pull the
    cover away from the transmitter to remove it.

2.  Install the battery as indicated by the polarity symbols (+ and -)
    marked inside the compartment.

3.  Replace the cover.  Be sure it snaps into place.


(PH 11/8/95)